Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
Take Precaution To ensure the safety of children and the TV, keep children away from the TV during Installation during installation. Climbing on or pushing the TV or its stand may cause it to fall and damage the TV. Preventing the TV As a protective measure, secure the TV as follows. from Toppling Over Using the TV stand with support belts . Sony strongly recommends using the TV stand SU-RS11M (for KDS50A2000)/ SU-RS11X (for KDS-55A2000, KDS-60A2000) with a support belt designed for your TV. . When using the SU-RS11M (for KDS-50A2000)/SU-RS11X (for KDS55A2000, KDS-60A2000) stand for your TV, you must use the support belt. Getting Started 11 Getting Started When Installing Your TV against a Wall Keep your TV at least 4 inches (10 cm) away from the wall to provide proper ventilation. Blocking the ventilation opening of the cooling fan may damage the TV. 12 inches (approx. 30cm) 4 inches 4 inches (10cm) 4 inches (10cm) (10cm) Never install the TV as follows Air circulation is blocked Air blown into the cooling fan . Do not install the TV near any ventilation, as it may affect the normal TV operating temperature. Getting Started Recommended Your viewing position may affect the picture quality. Viewing Area For the best picture quality, install your TV within the areas shown below. Model Viewing distance KDS-50A2000 min. 6.6 ft. (approx. 2.0 m) KDS-55A2000 min. 6.8 ft. (approx. 2.1 m) KDS-60A2000 min. 7.0 ft. (approx. 2.2 m) Vertical Viewing Area Horizontal Viewing Area 30° 30° (apprphe (appr e p s min.55 inches min. 6.8 ft. (approx. 2.1 m) 50 inches min. 6.6 ft. (approx. 2.0 m) 60 inches min. 7.0 ft. (approx. 2.2 m) 65.65. 6565° 65° 65° 6.6 ft.6.6 f m" 55 inches min. 6.8 ft. (approx. 2.1 m) 50 inches min. 6.6 ft. (approx. 2.0 m) 60 inches min. 7.0 ft. (approx. 2.2 m) . Install the TV in a location that avoids reflections from external light sources. . Reflections from external light sources may cause unwanted illuminations in certain areas of the picture (typically dark areas). These types of illuminations can occur with the TV’s power on or off. Getting Started 13 Getting Started Connecting the TV Cable System and VHF/UHF Antenna System Cable Box/Digital Cable Box and Antenna zTo change channels using the cable box, set your TV to channel 3 or 4 depending on the cable box channel output. To display clear crisp pictures, you must connect your TV correctly and select the correct Wide Mode to display the picture in the correct aspect ratio (see “Changing the Wide Screen Mode” on page 25). It is strongly recommended that you connect the antenna/cable input using 75-ohm coaxial cable to receive optimum picture quality signal. A 300-ohm twin lead cable can be easily affected by radio noise and the like, resulting in signal deterioration. If you use a 300-ohm twin lead cable, keep it as far away from the TV as possible. Do not use an indoor antenna, which is especially susceptible to radio noise. You can also connect a variety of optional equipment to your TV (see page 15). For multiple equipment connections, please refer to the separate Quick Setup Guide. Antenna cable CATV cable . Press ANT to switch between VHF/UHF and cable. Use this hookup if . Your cable company scrambles some channels, such as premium channels. Viewing all channels requires a cable box. . You do not intend to hook up any other audio or video equipment to your TV. CATV cable Antenna cable Cable box Coaxial IN OUT VHF/UHF cable CABLE Rear of TV . To set up the TV remote control, see “Programming the Remote Control” on page 26. . Press SAT/CABLE to begin operating the cable box with the remote control (see page 22). The indicator will light up. . Press ANT to switch between VHF/UHF and cable. Cable Box/ Digital Cable Box zTo change channels using the cable box, set your TV to channel 3 or 4 depending on the cable box channel output. Satellite Receiver and Cable/Antenna Getting Started Use this hookup if . You subscribe to a cable TV system that uses scrambled or encoded signals requiring a cable box to view all channels, and . You do not intend to hook up any other audio or video equipment to your TV. CATV cable Coaxial cable CABLE Rear of TV IN OUT Cable box . To set up the TV remote control, see “Programming the Remote Control” on page 26. . Press SAT/CABLE to begin operating the cable box with the remote control (see page 22). The indicator will light up. Rear of TV Getting Started CABLE VHF/UHF Satellite antenna Coaxial 54318 AUDIO AUDIO RGB PC IN VIDEO IN HD/DVD IN VIDEO S VIDEO (MONO) R L AUDIO R L R L (1080i/720p/480p/480i) PR AUDIO OUT DIGITAL OUT (OPTICAL) (VAR/FIX) PB Y SERVICE ONLY Satellite receiver A/V cable VIDEO (yellow) S VIDEO S VIDEO cable AUDIO-L (white) AUDIO-R (red) cable cable . If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. 15 Getting Started VCR and Cable Rear of TV CABLE VHF/UHF 54318 AUDIO AUDIO RGB PC IN VIDEO IN HD/DVD IN VIDEO S VIDEO (MONO) R L AUDIO ...
Otros modelos de este manual:TV - GRAND WEGA KDS-60A2000 (5.67 mb)