Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
This product is equipped with a polarized alternatand wall mounting instructions. An appliance and ing current line plug (a plug having one blade wider than the other). cart combination should be moved with care. This plug will fit into the power outlet only one way. This is a safety Quick stops, excessive force, and uneven surfaces may cause the feature. If you are unable to insert the plug fully into the outlet, try appliance and cart combination to overturn. reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purvided for ventilation. To ensure reliable operation of the appliance and 2. Slots and openings in the cabinet and in the back or bottom are propose of this polarized plug. Do not overload wall outlets, extension to protect it from overheating, these openings must not be blocked or cords, or integral convenience receptacles as this can result in a covered. The openings should never be covered with a cloth or other risk of fire or electric shock. material, and the bottom openings should not be blocked by placing 6. Power-supply cords should be routed so that they are not likely to the unit on a bed, sofa, rug, or other similar surface. This appliance be walked on or pinched by items placed upon or against them, should never be placed near or over a radiator or heat register. This paying particular attention to cords at plugs, convenience receptaappliance should not be placed in a built-in installation such as a book-cles, and the point where they exit from the product. case unless proper ventilation is provided. Cleaning 3. Do not expose the appliance to rain or use near water . . . for example, 7. Before cleaning, unplug the unit from the wall outlet. Do not apply liquid near a bathtub, swimming pool, kitchen sink, in a wet basement, etc. cleaners or aerosol cleaners directly to the unit. Use a dry cloth forHooking Up Outdoor Antenna cleaning. LIGHTNING PROTECTION FOR YOUR ANTENNA AND SET AS PER Service & Repair NATIONAL ELECTRICAL CODE INSTRUCTIONS. 8. Unplug the appliance from the wall outlet and refer servicing to qual- EXAMPLE OF ANTENNA GROUNDING ACCORDING TO ified service personnel under the following conditions: NATIONAL ELECTRICAL CODE, ANSI/NFPA 70 A. If the power cord or plug is damaged or frayed. B. If liquid has been spilled into the appliance. C. If the appliance has been exposed to rain or water. D. If the appliance has been dropped or the cabinet has been damaged. E. If the appliance exhibits a distinct change in performance. F. If the appliance does not operate normally by following the operating instructions, adjust only those controls that are covered in the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the appliance to normal operation. 9. Upon completion of any service or repair, request the service technician’s assurance that only Factory Authorized Replacement Parts that have the same characteristics as the original parts were used, and that routine safety checks have been performed to determine 4. If an outside antenna is connected to the receiver, be sure the that the appliance is in safe operating condition. Unauthorized sub- antenna system is grounded so as to provide some protection stitutions may result in fire, electrical shock, or other hazards. against voltage surges and built up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information 10. Never add accessories that have not been specifically designed for use with respect to proper grounding of the mast and supporting struc-with this appliance as they may cause hazards. ture, grounding of the lead in wire to an antenna discharge unit, 11. For added protection during a lightning storm, or when the set is left size of grounding conductors, location of antenna discharge unit, unattended and unused for long periods of time, unplug it from the connection to grounding electrodes, and requirements for the wall outlet and disconnect the antenna. This will prevent damage to grounding electrode. the set due to lightning or power line surges. An outside antenna system should not be located in the vicinity of 12. Never push objects of any kind into this product through openings overhead power lines or other electric light or power circuits, or where as they may touch dangerous voltage points or short-out parts that it can fall into such power lines or circuits. When installing an outside could result in a fire or electric shock. Never spill liquid of any kind antenna system extreme care should be taken to keep from touching on the product. such power lines or circuits as contact with them might be fatal. NEC - NATIONAL ELECTRICAL CODEANTENNALEAD INWIREGROUNDING CONDUCTORS(NEC SECTION 810-21) GROUND CLAMPSANTENNADISCHARGE UNIT(NEC SECTION 810-20) GROUNDCLAMPELECTRICSERVICEEQUIPMENTPOWER SERVICE...