Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
Antenna Isolator Installation Guide (Depending on model)
CAUTION
- Use this to install TV in a place where there is a voltage
difference between TV Set and GND of antenna signal.
Do not use any unapproved items to ensure the safety and product
» If there is a voltage difference between TV Set and GND of
life span.
ENGLISH
antenna signal, the antenna contact might be heated and
Any damage or injuries caused by using unapproved items are not
excessive heat might cause an accident.
covered by the warranty.
Some models have a thin film attached on to the screen and this
- You can improve the safety when watching TV by efficiently
must not be removed.
removing power voltage from TV antenna. It is recommended
When attaching the stand to the TV set, place the screen facing
to mount the isolator to the wall. If it cannot be mounted to
down on a cushioned table or flat surface to protect the screen
the wall, mount it on the TV. Avoid disconnecting the antenna
from scratches.
Isolator after installation.
Make sure that the screws are inserted correctly and fastened
- Before starting, be sure that the TV antenna is connected.
securely. (If they are not fastened securely enough, the TV may tilt
1. Connect to TV.
forward after being installed.) Do not use too much force and over
Wall
tighten the screws; otherwise screw may be damaged and not
ANTENNA/
CABLE IN
or
tighten correctly.
Make sure to wring any excess water or cleaner from the cloth.
Cable /
Do not spray water or cleaner directly onto the TV screen.
Antenna
Isolator
Make sure to spray just enough of water or cleaner onto a dry cloth
2. Connect to Set-Top box.
to wipe the screen.
When cleaning the product, be careful not to allow any liquid or
Connect one end of the isolator to cable/antenna jack and the other to
foreign objects to enter the gap between the upper, left or right
TV set or set-top box.
side of the panel and the guide panel. (Depending on model)
“Equipment connected to the protective earthing of the building
installation through the mains connection or through other equipment
with a connection to protective earthing - and to a cable distribution
system using coaxial cable, may in some circumstances create a fire
hazard. Connection to a cable distribution system has therefore to be
provided through a device providing electrical isolation below a certain
frequency range (galvanic isolator, see EN 60728-11)”
Separate purchase
When applying the RF Isolator, a slight loss of signal sensitivity can
Separate purchase items can be changed or modified for quality
occur.
improvement without any notification. Contact your dealer to buy these
items. These devices only work with certain models.
The model name or design may be changed depending on the upgrade
of product functions, manufacturer’s circumstances or policies.
(Depending on model)
AG-F***
AN-MR650
Cinema 3D Glasses
Magic Remote
AN-VC550
AG-F***DP
Smart camera
Dual Play Glasses
9
...Otros modelos de este manual:
TV - 75UH780V (17.34 mb)