Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
The information in this publication does not represent a commitment on the part of Welch Allyn. Welch Allyn shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. This document contains proprietary information which is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of Welch Allyn, Incorporated. © 1998 - 1999 Welch Allyn, Inc. Statement of Agency Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Class A Compliance Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. Caution: Any changes or modifications made to this device that are not expressly approved by Welch Allyn, Inc. may void the user's authority to operate the equipment. Note: To maintain compliance with FCC Rules and Regulations, cables connected to this device must be shielded cables, in which the cable shield wire(s) have been grounded (tied) to the connector shell. Canadian Notice This equipment does not exceed the Class A limits for radio noise emissions as described in the Radio Interference Regulations of the Canadian Department of Communications. Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de la classe A prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada. SCANTEAM 3400PDF User’s Guide Statement of Agency Compliance C€ The CE mark on the product indicates that the system has been tested to and conforms with the provisions noted within the 89/336/EEC Electromagnetic Compatibility Directive (Class A) and the 73/23/EEC Low Voltage Directive. Welch Allyn shall not be liable for use of our product with equipment (i.e., power supplies, personal computers, etc.) that is not CE marked and does not comply with the Low Voltage Directive. SCANTEAM 3400PDF User’s Guide TABLE OF CONTENTS Section 1 Introduction & Quick Start Menu Section Page Introduction ......................................................................1-1 Scanner Identification ....................................................1-2 Connecting the Scanner ................................................1-3 Scan Maps........................................................................1-4 Plug and Play Selections IBM PC Interface ............................................................1-7 RS232 Interface ..............................................................1-7 Wand Emulation Interface..............................................1-8 Terminal Interface Selections Supported Terminals ......................................................1-9 Reset Factory Settings ..................................................1-11 Status Check....................................................................1-11 Section 2 Output Parameters Menu Section Page Introduction ......................................................................2-1 Prefix / Suffix Selections Quick Suffix Selections ..................................................2-2 Primary Interface Prefix Selection................................2-4 Primary Interface Suffix Selection ................................2-4 Exit Selection for Prefix / Suffix ....................................2-4 Output Selections Beeper Volume Selection ..............................................2-8 Ticking/Scanning Progress Selection ..........................2-8 Humming/Busy Decoder Selection ..............................2-8 Output Delays Selection ................................................2-9 AutoTrigger Selection ....................................................2-10 Reread Delay Selection..................................................2-10 Good Read Delay Selection..........................................2-10 Scan Voting Selection ....................................................2-11 Code I.D. Transmit Selecti...