Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
To minimize risk, please follow these rules: 1. Consult your physician before beginning any exercise program. 2. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately. Failure to do so may result in serious injury. 3. Do not allow minors or children to play on or around this equipment. 4. Exercise with care to avoid injury. 5. If unsure of propter use of equipment, call your local Parabody distributor or call the Parabody customer service department at (800) 328-9714. Please note: * Thank you for purchasing the Parabody 914101 ST PLATE RACK. Please read these ' instructions thoroughly and keep them for future reference. This product must be assembled on a flat, level surface to assure its proper function. * We recommend cleaning your product (pads and frame) on a regular basis, using warm soapy water. Touch-up paint can be purchased from your Parabody customer seivice representative at (800) 328-9714. Tools Required for Assembly * 3/4” wrench * Ratchet with 3/4” socket * Tape measure * 7/32 Allen wrench Bolt Length Ruler NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT. BOLT LENGTH RULER: BOLT LENGTH PARTS LIST KEY PART# DESCRIPTION yiv 1 6690101 FRAME WELDMENT 1 2 6690401 1-1/2” DIAX 19” TUBE 4 3 3102502 3/8” LOCKWASHER 4 4 3102910 1/2 X 3” BOLT 4 5 3102801 1/2” LOCKNUT 4 6 3102502 RUBBER BUMPER 8 7 3102502 1/2” FLAT WASHER 4 8 3202401 3/8 X 1” BUTTON HEAD CAP SCREW 4 9 6615503 3 X 2 X 18” TUBE 2 STEP 1: SECURELY assemble two 3 X 2 X 18” TUBES (9) to the FRAME WELDMT (1) using four 1/2 X 3” BOLTS (4) four 1/2” FLAT WASHERS (7) and four 1/2” LOCKNUTS (5) as s;hown in FIGURE 1. STEP 2: Insert the four 1-1/2 DIA X19” TUBES (2) through the side of FRAME WELDMEI'iT (1) so the threaded hole in the 19” TUBES (2) lines up with the holes in the FRAME WELDMENT (1) as shown in FIGURE 2. STEP 3: SECURELY assemble the four 1-1/2” DIA X 19” TUBES (2) to the FRAME WELDMENT (1) using four 3/8-16 X1” BUTTON HEAD CAP SCREWS (8) and four 3/8” LOCKWAS1EEERS (3) as shown in . FIGURE 2. STEP 4: Slide eight RUBBER BUMPERS (6) over the ends of the 1-1/2” DIA X19” TUBES (2) and up against the FRAME WELDMENT (1) as shown in FIGURE 4....