Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
TO APPLY LUBRICANT TO THE WALKING BOARD 1) Position the walking belt so that the seam is located on top and in the center of the center of the walking board. 2) Insert the spray nozzle into the spray head of the lubricant can. 3) While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board approximately 6” from the front of the treadmill. Apply the silicone spray to the walking board, moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4 seconds on each side. 4) Allow the silicone to ‘set’ for one minute before using the treadmill. 16 Troubleshooting Guide Treadmill will not start. 1) Is the RED Safety Key Attached to the Console? 2) Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded outlet, and the surge protector is turned on. (Refer to “Power Requirements”) 3) Check the circuit breaker located on the front of the treadmill. If the switch protrudes, it has tripped. Wait five minutes and then press the switch back in. 4) Check the house electrical breaker box and the circuit breaker for the room the treadmill is located in. If it has tripped, reset or have an electrician replace the breaker in home. 5) Have an electrician check for inadequate voltage at the outlet. Treadmill looses power during use. 1) Check the circuit breaker located on the front of the treadmill. If the switch protrudes, it has tripped. Wait five minutes and then press the switch back in. 2) Check the house electrical breaker box and the circuit breaker for the room the treadmill is located in. If it has tripped, reset or have an electrician replace the breaker in home. 3) If treadmill still will not operate, please call Keys Technical Service at (888) 340-0482. Treadmill walking belt slows during use. 1) Check to make sure the treadmill is securely plugged into an UL-listed surge protector, rated at 15 amps, with a 14-guage cord of five feet or less and the surge protector is securely plugged into the outlet. 2) If treadmill still will not operate, please call Keys Technical Service at (888) 340-0482. Treadmill walking belt slips or is not centered on rear roller. 1) Refer to “Belt Adjustment and Tension” section. 2) Need help? Call Keys Technical Service at (888) 340-0482. Treadmill Error Messages. 2)Your treadmill is equipped with a software package that enables error messages to be displayed when there is a problem. To avoid possible damage to the treadmill and the possibility of injury, do notoperate the treadmill until the problem is corrected. Call Keys Technical Service at (888) 3400482. 17 Parts List - Alliance 815 and 835HR KEY # PART # DESCRIPTION QTY KEY # PART # DESCRIPTION QTY 1 UP 3K ASSB UPRIGHT ASSEMBLY 1 53 08-0004 CIRCUIT BREAKER 15 AMP 1 2 20-0001 DECK ASSEMBLY 1 54 13-0017 TELCO HARNESS FOR HEART RATE 1 3 20-0003 ELEVATION ASSEMBLY 1 55 11-0002 REAR ELEVATION BUSHING 2 4 SES EXT S.E...
Otros modelos de este manual:Formadores - 815 (825.87 kb)
Formadores - 835HR (825.87 kb)
Formadores - 815 (825.87 kb)
Formadores - 815 (825.87 kb)