Votos - 2, Puntuación media: 5
(
)
)
|
Fotos y especificaciones Vision Fitness X6150 |
Resumen del manual
Also, during each assembly step, ensure that ALL bolts and screws are in place and partially threaded in before completely tightening any ONE bolt or screw. STEP 3 • Slide the console mast boot onto the console mast. • Unwrap the wire harness located in the console mast frame bracket. Take the wire tie that exits the bottom of the console mast and wrap it around the end of the wire harness. Pull the wire tie up through the top of the console mast and slide the bottom of the console mast over the console mast frame bracket. • Insert a socket head bolt (M8x25L) with a lock washer (M8) and a flat washer (8x18x1.5T) to each of the four mounting holes on the sides of the console mast. Insert a socket head bolt (M8x25L) with a lock washer (M8) and an arc washer (8x18x1.5T) to the mounting hole on the backside of the console mast. When all bolts are in place tighten the bolts with the 6mm L-shaped wrench. Insert two sets screws (M8x10L) to the nuts welded in the front side of console mast and tighten them with a 4mm L -shaped wrench. • Slide the console mast boot down in place over the frame covers. • Remove the four mounting screws from the backside of the console. Plug the wire harness and heart rate wires into the back side of the console. Mount the console to the console mast with the four screws removed earlier in this step. X6250 ONLY: Set the accessory tray on the console mast handlebars. Secure in place with four screws (M5x12L). Tighten with the screwdriver. X6150 ONLY: Remove the water bottle cage mounting screws from the console mast with the screwdriver. Mount the bottle cage to the mast with these same screws. Insert water bottle. PINK BAG STEP 1 • Slide the right transport wheel into the front tube. Align the holes in the front tube with the screw holes in the transport wheel sleeve. Insert two screws (M4x15L). Tighten with the screwdriver. • Repeat these steps on the left side. ORANGE BAG STEP 2 • Slide the knuckle joint sleeve of the right pedal arm assembly onto the pin on the right side cover disk. Secure in place with a washer (8x25x1.5T) and bolt (M8x20L). Tighten with the 5mm T-handle wrench. • Slide the knuckle joint cover over the knuckle joint. Fix in place with a washer (5x10x1T) and a bolt (M5x10L). Tighten with the screwdriver. • Attach a cover to the left and right side of the link arm connection joint. Fix each side in place with a washer (5x10x1T) and a bolt (M5x10L). Tighten with the screwdriver. • Assemble the pedal footwell onto the right pedal arm with four flathead bolts (M5x12L). Tighten with the screwdriver. • Insert the footwell cushion into the footwell. Make sure all pegs are seated into their respective holes. • Repeat these steps on the left side. BLUE BAG STEP 3 STEP 4 STEP 2 Knuckle Joint Sleeve Knuckle Joint Cover Pedal Footwell Console Mast Boot Wire Harness Console Mast Console Mast Frame Bracket Dual-Action Arm Rotation Housing Rotation Housing Cap Link Arm Axle Sleeve STEP 1 X6250HRT ONLY Transport X6150 Wheel ...
Otros modelos de este manual:Formadores - X6250HRT (1.6 mb)