Votos - 3, Puntuación media: 3.3
(
)
)
|
Resumen del manual
–Do not set up your tent under trees. –For best results in windy conditions, position the end of tent into the wind. –See owners manual for more tips through pole sleeves 1 Layout & Positioning of Tent –Layout and position tent with door facing desired direction. (illus. 1) –Stake down tent, starting with the corners. Do not stretch too tight. Angle the stakes End roof illus. 1 Front door sleeve slightly toward the tent. (illus. 2) Keep the floor taut. illus. 2 –Unzip the door. Stake loops properly staked Forms an arch 2 Assemble & Place Roof Poles –Assemble all shock-corded roof poles. When assembled will form a continuous arch with both ends pointing down. (illus. 3) –Select center roof poles (longer,3 section) and insert them diagonally through the two center roof sleeves. They cross and form an “X”. (illus. 1 & 4) –Select end roof poles (shorter, 2 section). and insert them through the roof sleeves at each end of the tent. (illus. 1) POLE ASSEMBLY PARTS Center Curved Roof Poles Part No. 9271-205 End Curved Roof Poles Part No. 9271-206 Center Brace Poles Part No. 9271-202 End Brace Poles Part No. 9271-203 Rainfly Poles Part No. 9271-204 Rainfly Part No. 9271-201 Center curved roof poles diagonally Shock corded poles illus. 3 Three section curved roof pole assembly. Pole sleeves illus. 4 Curved roof pole system shown inserted diagonally through pole sleeves. center of the tent. (illus. 9) –Brace poles attach to squeeze pins at edge of tent. (illus. 8) Shown with center brace poles and end brace poles in position. Center brace pole illus. 8 Rainfly poles through pole sleeves Rainfly pole inserts into grommets on tent 4 illus. 9 Tent shown completely set-up. Attach Rainfly –Assemble rainfly poles,by interlocking shock-corded poles. –Insert rainfly pole through the pole sleeves located at the center edges of the underside of rainfly. (illus. 8) –Drape rainfly over tent frame, pole side down. rainfly poles go over door and rear window and attach “S” hooks on rainfly into holes in brace poles. (illus. 11) –Secure rainfly with hook & loop fasteners located on underside of fly. (illus. 9) –Insert tip of rainfly pole into the grommet on the front of the tent and gently arch the pole until you can insert the opposite end in the other grommet.. Repeat for back side of tent. (illus. 6 & 9) –Stake out rainfly ends using included guylines. (illus. 10) Brace pole with hole for rainfly “S” hooks illus. 10 Stake out rainfly ends. Slide the disc up the rope to tighten guyline. illus. 7 Insert squeeze pin into pole Attach Rainfly –Assemble rainfly poles,by interlocking shock-corded poles. –Insert rainfly pole through the pole sleeves located at the center edges of the underside of rainfly. (illus. 8) –Drape rainfly over tent frame, pole side down. rainfly poles go over door and rear window and attach “S” hooks on rainfly into holes in brace poles. (illus. 11) –Secure rainfly with hook & loop fasteners located on underside of fly. (illus. 9) –Insert tip of rainfly pole into the grommet on the front of the tent and gently arch the pole until you can insert the opposite end in the other grommet.. Repeat for back side of tent. (illus. 6 & 9) –Stake out rainfly ends using included guylines. (illus. 10) Brace pole with hole for rainfly “S” hooks illus. 10 Stake out rainfly ends. Slide the disc up the rope to tighten guyline. illus. 7 Insert squeeze pin into pole 3 Raise Tent –Assemble center shock-corded brace poles (longer poles). –Insert square end of brace poles into curved roof poles and raise tent upright. (illus. 5, 6) –Brace poles should attach to squeeze pins at bottom of tent. (illus 7) –Assemble end (shorter) shock-corded brace poles. –Insert end brace poles into end roof assemblies. MAKE SURE when attaching the brace poles to the curved poles that the bottom of the brace pole naturally points down and toward the illus. 5 When attaching the brace poles to the curved poles make sure that the brace poles naturally point straight down. Grommets for rainfly pole End brace pole illus. 6 Brace pole Curved poles in pole sleeve Things You Should Know • Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent. • Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag. • STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE. • TENT POLES SHOULD NOT BE LEFT TELESCOPED TOG...