Votos - 6, Puntuación media: 4
(
)
)
|
Resumen del manual
This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective. DO NOT... 1. Do not pitch tent near an open flame. 2. Do not leave campfires unattended. 3. Do not allow CHILDREN or ADULTS to use lighted candles, matches or other flame sources in or near tents. 4. Do not use heating, lighting or cooking equipment with open flames in or near tents. 5. Do not use fuel burning/oxygen consuming devices (i.e. heaters, lanterns, or other flame sources) inside your tent at any time. 6. Do not use other than recommended water repellent compounds on your tent.(See:“Seal the Seams”) 7. Do not spray the tent with insecticide. 8. EXTREME CAUTION: Never use any fuel burning/oxygen consuming device, or any device that produces fumes (including stoves, lanterns, candles, hibachis, or heaters) in or around your tent. Inhalation of fumes may result in carbon monoxide poisoning, injury and/or death. DO... 1. Always extinguish campfire before leaving area. 2. Exercise care when using electricity and lighting in and near tents. 3. Disassemble and store tent properly after camping to ensure the tent’s longevity. 4. Always use a hammer/mallet when driving stakes into the ground. This recreational item is not intended for use as a permanent structure, as fabric will quickly degrade if exposed to UV light. No (sun shelter, screenhouse, tent) can withstand prolonged exposure to sunlight. UV damage is not covered under the limited 90 day warranty. Structural Integrity Although our tents and screenhouses are constructed to rigid specifications, periods of wind or rain soaking the ground may loosen the stakes and cause the uprights to sink into the ground. This will weaken the rigidity of the overall structure. Water pockets may also form in the roof if the unit is not assembled taut, the weight of which may cause broken frames and torn fabric. Storage Tents/screenhouses must never be rolled up or packed while damp, as mildew will form within a few days. Allow tent to dry completely before rolling and storing. LIMITED 90 DAY WARRANTY For 90 days from the date of purchase, Ozark Trail will replace, at our option, defects in material or workmanship that appear in this product, free of charge. Product must be original factory packaging and unmodified. You must have a copy of your Wal-Mart receipt. Warranty service is available by calling: toll free 1-800-775-1965 Mon.–Fri, 7:00 a.m. to 4:00 p.m. (PST-West Coast) Ozark Trail 3333 Yale Way • Fremont, CA 94538-6169 This warranty gives you specific legal rights.You may also have other rights which vary from state to state. REPLACEMENT PARTS 1 GBLL-03 4 5 1B 1B 1 1B Model # WMT-1390S-1 HOW TO ORDER REPLACEMENT PARTS Always mention the Model number in all correspondence regarding your tent and when ordering replacement parts. To order replacement parts listed below, or for any questions regarding your tent, call 1-800-775-1965 Mon.–Fri, 8:00 a.m. to 5:00 p.m. (PST-West Coast) or write to: Ozark Trail • 3333 Yale Way • Fremont, CA 94538-6169 WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: 1. Model Number 2. Part Number 3. Part Descriptions GBLL-03 GBLT-03 1 5B 5 1B GBLR-03 GBLT-03 1B 2B 2B 2B 2 5B GBLR-03 PART NO. DESCRIPTION QTY. REQ. RPL2-03 Roof pole “2” 3 RP2B-03 Roof pole “2B” 9 SPL1-03 Side pole “1” 4 MPL5-03 Middle (roof ) pole ”5” with hook 2 MP5B-03 Middle (roof ) pole “5B” with hook 2 LPL4-03 Leg pole “4” with holes 4 PL1B-03 Pole “1B” used on side and leg 12 GBLL-03 3 way hub Gable L 2 GBLR-03 3 way hub Gable R 2 GBLT-03 3 way hub Gable T 2 CBAG-03 Carry bag 1 PBAG-03 Pole bag 1 SBAG-03 Stake bag 1 UN-GROPE Guy rope 4 UN-75ABSSTK 7.5" Steel Stake 18 UN-DRING Steel D-ring 8 UN-STSHOOK Steel S-hook 4 PSET-03 Poles/ set of 36 1 SSET-03 Stakes/ set of 18 1 ASSEMBLY INSTRUCTIONS: WMT-1390S-1 IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE GOING CAMPING TO ASSURE THAT ALL PARTS ARE PRESENT AND TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT. To prolong the life of the tent floor, select a level, clean area for the campsite. Step 1 – Lay Out the Screenhouse and Poles Select a smooth, level site and spread out your screenhouse. Sort the poles by number and connect the sections together. See diagrams below for numbering. 2B 2B 2B 2 2B 2B 2B 2 2B 2B 2B 2 Diagram 1 T L T L R R 1B 1 1 1B 1 T L 5 5B 1B R R L 5B 5 2 2B 2B 2B T Diagram 2 hub Insert the leg poles into the hubs to raise the screenhouse frame. Make sure that the pole end with the holes in the sides ( C ) is pointing down. See Diagram 3. Step 3 –Secure the Screenhouse Drape the screenhouse body over the frames. Hook the S-Hooks B into one of the holes located at the bottom of the leg poles. Wrap the velcro tape D , located inside the screenhouse, around the poles to secure them. When the screenhouse is in its proper location, st...