Iniciar sesión:
Votos - 0, Puntuación media: 0 ( )

Manual de usuario HP, modelo HP StoreEver MSL6480 Scalable Base Module

Fabricar: HP
Tamaño del archivo: 2.26 mb
Nombre del archivo:
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Otros manuales para este modelo:

Resumen del manual


4.
If there are adjacent modules:
a.
From the front of the library, use your fingers
TIP:
To assist in aligning the drive, only
to loosen the captive thumbscrews on the
remove the drive bay covers for one drive
replacement module and all modules above
at a time.
it two full turns.
b.
From the back of the library, starting with the
4.
Replace the power supplies.
replacement module and the one below it,
5.
Reattach any SAS, FC, expansion interconnect,
align the modules and lock them together.
and Ethernet cables removed earlier.
Repeat for each pair of modules.
6.
Reinsert the USB device if you removed it earlier.
i.
Use your fingers to loosen the
7.
Reattach the power cords.
thumbscrew on the alignment
mechanism that will connect the upper
module with the lower module.
ii.
Lower the alignment mechanism. If you
Verifying the library configuration
encounter resistance, adjust the upper
Power on the library by pressing the button just below
module so the pin in the alignment
the OCP.
mechanism moves into the hole in the
lower module. When the alignment
Verify that the library initializes correctly and that the
mechanism is in the locked position,
status is Ready. Verify that the replacement module is
tighten the thumbscrew with your fingers.
visible in the OCP or RMI.
Under normal operation the library configuration is
saved on the base module controller. For instructions
on restoring the library configuration or for
2
1
troubleshooting information, see the HP StoreEver
MSL6480 Tape Library User and Service Guide
available from the HP website: http://www.hp.com/
go/msl
.
Replace the tape cartridges in the same locations.
3
Getting help

HP Product information: http://www.hp.com/go/
c.
From the front of the library, tighten the
msl
thumbscrews on all modules with your

fingers.
HP technical support and phone numbers:
www.hp.com/support

HP Library & Tape Tools (L&TT) diagnostic
software: www.hp.com/support/tapetools
Replacing the module components and
cables
Replace the module components by reversing the
Documentation feedback
removal procedures. Align the components carefully
in the guide slots and only tighten thumbscrews with
Send any errors, suggestions, or comments to
your fingers. If the thumbscrews cannot be tightened
Documentation Feedback (docsfeedback@hp.com).
easily, verify that the component is aligned properly.
1.
Replace the drive power boards and chassis fan
assembly.
2.
Replace the controller board.
3.
Replace the tape drives in the same locations .
Page 7


...


Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría