Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
The jet of steam feature can be used only in the 11 Q 11 indication area of the temperature selector dial when steam or dry ironing (If used at lower setting, water spotting will occur because the iron is not hot enough to change water to steam). If you have not used the "Jet of Steam" feature for a long time, it is necessary to clean the inside of the iron before using this feature on any clothes to be ironed. Simply test the "Jet of Steam" feature several times away from the ironing board and clothes to be ironed. This will prevent brown spotting or water spotting on the clothes. -7- 1. Fill the iron as described in "HOW TO FILL" 2. Set the iron vertically and make sure the temperature selector dial is set to OFF. Plug the AC cord into the electrical outlet. 3. Set the temperature selector dial to the " " indication area. 4. Preheat the iron until the indicator light goes out, usually about 1-2 minutes. 5. Simply pump the jet of steam button when it is desired. But pump the jet of steam button several times before using for the first time at each ironing session. 6. Allow at least 5 seconds between uses of jet of steam to prevent water spotting. Use a press cloth if necessary. VERTICAL STEAM(NI-560R Only) To get better results when using vertical Jet of steam, hang the garment on a clothes hanger. Curtain and drapes may also be steamed once they're hung. Hold the iron away from your body close to but not touching the fabric. Pull the fabric tight with your free hand and pump the Vertical steam button (Jet of Steam Button) at 5-second intervals as you pass the iron over the wrinkled fablic. WARNING: Never iron clothes on the body or point your iron at anyone when steaming. Keep hands and body away from steam areas while using vertical steam feature. /This picture \ \ is NI-560R/ SELF-CLEANING With the self-cleaning feature you can flush out mineral residues from the steam generating chamber and the steam vents - refreshing your iron each time for a longer steaming life. It is very important to operate the self-cleaning feature after each steam ironing to prevent mineral accumulations from hardening. 1. Check water level. Water jeygl should be at the 1/2 full. When water level is below 1/2 full, with water according to the instructions in "How to Fill". 2. Preheat at "6" setting, (in about 1-2 minutes) Make sure that the steam button is in the Dry position. 3. Set the dial to off and remove the AC plug. 4. Hold the iron horizontally over the sink. 5. Pump the "Jet of Steam" button quickly (at least 3 times per second) about 20-30 times. 6. While self-cleaning, pitch the iron up and down slowly to help clean the entire inside and let the water drip out of the sole plate vents. -8- 7. Check that all water and steam thoroughly stop coming out of the sole plate vents. After ...
Otros modelos de este manual:Planchas - NI350E (398.71 kb)