Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
Anti-drip function “Thermo-Alert” function (depending on model) - The “Thermo-Alert” light (O) comes on when you choose a program requiring a lower temperature (for example, changing from program 8 to program 6). It remains lit while the soleplate temperature is too high. - When it goes out, you can iron without risk of burning the fabric. O N 2- DRY IRONING - Choose your ironing program. - Set the steam control to DRY (see diagram A). - You may start ironing when the thermostat light goes out. • CLEANING THE ANTI-CALC VALVE (Once per month) : - Unplug your iron and empty the water tank. -To remove the anti-calc valve, select program 8, press the release button (P) and pull the valve upwards. NEVER TOUCH THE END OF THE VALVE. - Soak the valve in a cup of white spirit vinegar or plain lemon juice for 4 hours (Q). - Rinse the valve under running water. - Replace the anti-calc valve. THE IRON WILL NOT FUNCTION WITHOUT THE ANTI-CALC VALVE. 3- CARING FOR YOUR IRON BE CAREFUL ! Unplug your iron and let it cool down before cleaning it. • SELF-CLEANING : In order to extend the life of your iron, use the Self-Cleaning function once a month. - Set the steam control to steam ( ) -Allow your iron to heat up with the tank full and standing on its heel (on program 8). -When the thermostat light goes out, unplug the iron and hold it in a horizontal position, over a sink. - Remove the anti-calc valve. - Shake the iron gently, over the sink, until some of the water in the water tank (with the impurities) has flowed out through the soleplate. -At the end of the operation, push the anti-calc valve back into position. -Turn the iron back on for 2 minutes, setting it on its heel, to dry the soleplate. - Unplug the iron, and when the soleplate is just warm, wipe it with a soft cloth. • CLEANING THE SOLEPLATE : -While the soleplate is still just warm, clean it by rubbing it with a moist non-metallic pad. Recommendations : the self-cleaning function helps to slow down the scaling up of your iron. P Q FOR YOUR SAFETY • This appliance complies with the technical rules and standards for safety currently in force (Electromagnetic Compatibility, Low Voltage, Environnement). • This appliance is not designed to be used by people (including children) with a phy- sical, sensory or mental impairment, or people without knowledge or experience, unless they are supervised or given prior instructions concerning the use of the appliance by someone responsible for their safety. Children must be supervised to ensure that they do not play with the appliance. • Warning ! The voltage of your electrical installation must correspond to that of the iron (220V-240V or 127V depending on model). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee. • This iron must always be plugged into an earthed socket. If using a mains extension lead, ensure that it is correctly rated (10A or 13A, depending on model), with an earth connection. • If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to avoid any danger. • The appliance should not be used if it has fallen, if it has obvious damage, if it leaks or has functional anomalies. Never dismantle your appliance : have it inspected by an Approved Service Centre, so as to avoid any danger. • Never immerse your iron in water ! • Do not unplug your appliance by pulling on the cord.Always unplug your appliance: before filling or rinsing the reservoir, before cleaning it, after each use. • Never leave the appliance unattended when it is connected to a power source; if it has not cooled down for approximately 1 hour. • Your appliance gives off steam, which may cause burns, especially when you are iro- ning on a corner of your ironing board. Never direct the steam towards people or animals. • Your iron should be used and placed on a stable surface.When you put your iron onto its iron rest, make sure that the surface on which you put it is stable. • This product has been designed solely for domestic use.Any inappropriate use or use contrary to the instructions releases the brand from all responsibility and ren- ders the guarantee invalid. ENVIRONNEMENT PROTECTION FIRST ! ppliance contains valuable materials which can be recovered or recycled. .Leave it at a collection point. 4- STORING YOUR IRON - Unplug the iron and wait for the soleplate to cool down. - Empty the water tank and set the steam control to DRY.A little water may remain in the tank. -Wind the cord not too tightly around the heel at the back of the iron. - Store the iron on its heel. 2- DRY IRONING - Choose your ironing program. - Set the steam control to DRY (see diagram A). -You may start ironing when the thermostat light goes out. • CLEANING THE ANTI-CALC VALVE (Once per month) : - Unplug your iron and empty the water tank. -To remove the anti-calc valve, select program 8, press the release button (P) and pull the valve upwards. NEVER TOUCH THE END OF THE...
Otros modelos de este manual:Planchas - FV9330 (258 kb)
Planchas - FV9350 (258 kb)