Votos - 3, Puntuación media: 4 ( )

Fabricar: Braun Tamaño del archivo: 117.27 kb Nombre del archivo: Idioma del manual:

5. Close sliding shutter. Selecting the temperature Connect the iron to a safely located wall outlet and select the ironing temperature with the temperature selector 1 (b). As soon as the pilot light 8 goes out, the iron has reached the temperature selected. To avoid water dripping, always rest the iron upright while heating it up keep the steam regulator 4 in position « • » (= steam off) (c). You will usually find the following symbols in your garments: The temperature selector 1 is marked with these symbols: min. The iron is connected l Synthetics (acrylic, acetate) ll Silk/rayon/nylon/polyester/ cotton blends/wool lll Cotton/linen max. Linen Select the temperature you need according to these symbols. Spray, shot of steam, jet of steam Before you start ironing, we recommend to press the buttons 3 or 4 times, in order to activate these functions. Dry ironing Set the steam regulator 4 in position « • » (= steam off) (c) for dry spray 7 may be used at any temperature setting to dampen the laundry. 6 and the shot of steam 7 buttons can be activated during dry ironing, provided temperature selector 1 is within the continuous red area Steam ironing (see «Table of features») Temperature selection: Set the temperature selector 1 within the red range steam (b) and wait until the iron has reached the selected temperature (i. e. the pilot light 8 goes off). Steam ironing is possible in the entire red range. Steam ironing at lower temperatures may cause water drops instead of steam. Should this happen, turn the steam regulator 4 to the position « • » (= steam off) (c). Steam regulator 4 : Select the quantity of steam required (c) for each garment with the steam regulator 4 . You can increase the quantity by turning the steam regulator clockwise (wide markings) to the end of the red marking. Caution: While ironing do not turn the steam regulator further, otherwise hot water may come out from the sole plate (see section «Decalcifying/Self-cleaning »). By turning the steam regulator anti-clockwise you can reduce the quantity of steam or turn the steam off « • » (= steam off) (see «Ironing Guide»). Constant steam: Your Braun steam iron is equipped with a special tank configuration to provide constant steam even when the water level in the tank is low. « Extra steam »* (coming from the steam vents in the sole plate): For stubborn creases and wrinkles, collars and cuffs. When ironing within the red range area the extra steam function can be used. You can press the button 5 (d) for 3 seconds at intervals of no less than 15 seconds. Jet of steam* (coming from the outlets p at the slim pointed tip o ): Caution: Keep chil-dren away from the jet of steam and do not hold your fingers in front of the outlets p when activating this function. When ironing within the red range area the jet of steam function 6 can be used (e). To do so, press the button 6 at intervals of no less than 5 seconds. The jet of steam has been designed not only for steaming hard to reach areas like pleats, inside of pockets etc., but also for steaming hanging clothing (e. g. velvet skirts, curtains, etc.) (g). The jet of steam functions between horizontal and upright positions. Be careful not to touch sensitive textiles with the hot sole plate. Shot of steam* (coming from the vents in the sole plate): When ironing within the red area the shot of steam function can be used. It gives an extra, particularly powerful shot of steam penetrating deep into the tex...

Descargar ahora

Introduzca dos números de la imagen: