This should be performed once every 3 or 4 uses. 1. When the iron is cold, slide the steam regulator (C) between the and positions in quick succession about 3 or 4 times to help loosen any lime scale and clean the valve inside. 2. Heat up the iron. Before starting ironing, hold the iron horizontally over a sink and press the shot of steam button (A) 3 or 4 times. This will help force out any lime scale and dirt deposits through the holes in the soleplate. 11 Multiple de-scaling system This range of irons is equipped with the following de- scaling features “AntiCalc”. A. self-clean Each time you use the steam regulator (C), the “self-clean” system cleans the mechanism of any scale deposits. B. calc‘n-clean The “calc’nclean” function helps to remove scale particles out of the steam chamber. Use this function approximately every 2 weeks, if the water in your area is very hard. 1. Unplug the iron from the mains socket, set the steam regulator (C) to the position and fill the water tank (E) with water. 2. Set the temperature selector (I) to the “max” position and plug in the iron. 3. After the necessary warm-up period, the pilot light (K) goes out. Then, unplug the iron (very important!). 4. Hold the iron over a sink. Press the “clean” button (G) until approximately one third of the water capacity of the tank is evaporated. Boiling water and steam will come out, carrying scale or deposits that might be there. 5. Release the “clean” button, and gently shake the iron for some seconds. 6. Repeat the steps 4 and 5 three times until the tank is empty. Then plug the iron in and heat it up again until the remaining water has evaporated. 7. Unplug the iron and let the soleplate (F) cool down. Wipe the soleplate with a damp cotton cloth only. C. anti-calc cartridge The anti-calc cartridge has been designed to reduce the build- up of scale produced during steam ironing, helping to extend the useful life of your iron. Nevertheless, the “anti-calc” cartridge cannot remove all of the scale that is produced naturally over time. 12 Anti-drip system “Drip Stop” The irons in this range are equipped with an anti-drip system. This will automatically stop the iron producing steam when the selected temperature setting is too low to prevent water from dripping out of the soleplate. You may hear a clicking sound when this system is in operation. Additional Features 13 Auto shut-off “secure” (Model Dependent) Some irons in this range are equipped with an auto-shut off system. The “secure” auto shut-off function switches off the iron automatically when it is not being used, thus helping to prevent accidents and saving energy. When the appliance is first plugged in, this function will be inactive for the first 2 minutes to allow it to reach the set temperature. If during ironing, the iron is not moved for a certain length of time, the iron will automatically switch off. The length of time will depend on the position the iron has been left in: Horizontally (flat) or on its sid...

Otros modelos de este manual:
Planchas - TDA7630GB/02 (650.76 kb)
Planchas - TDA7631GB/01 (650.76 kb)
Planchas - TDA7635GB/01 (650.76 kb)
Planchas - TDA7635GB/02 (650.76 kb)