Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
• Children should be supervised to ensure that they do not play with the appliance. • Never leave the appliance unattended : - when it is connected to the mains, -until it has cooled down (around 1 hour). • The soleplate and generator iron-rest can become very hot and cause burns: never touch these parts. Never touch the electric cords with the soleplate of the iron. • Your appliance gives off steam which can cause burns. Handle your iron carefully, particularly when using the vertical steam function. Never direct the steam towards persons or animals. • Before unscrewing the boiler rinse cap, wait until the generator is cold (unplugged for more than 2 hours). • While rinsing out the boiler, never fill it directly under the tap. • If you lose or damage the boiler rinse cap, have it replaced by an approved Service Centre. • Never immerse your steam generator in water or any other liquid. Never hold it under the water tap. • The appliance must not be used if it has fallen to the floor, shows evidence of damage, leaks or fails to function correctly. Never dismantle your appliance. To avoid any danger, have it inspected in an approved service centre. • This appliance has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Description 1. Steam control button 12. Steam generator boiler (in the base 2. Iron temperature adjustment button unit) 3. Iron thermostat light 13. Iron-base steam cord GB 4. Easycord system (depending on model) 14. Slide storage place for the steam cord 5. Iron rest 15. a -Boiler rinse cap cover 6. Illuminated on / off switch b -Boiler rinse cap 7. Power cord storage space 16. Control panel 8. Power cord a-Restart button 9. Lock-System hoop (depending on model) b- “Water tank empty” light 10. Water tank filler cover c-“Steam ready” light 11. Water tank d- “Boiler rinse” light e-Steam output control dial Locking system for retaining the iron on the base - Lock-system (depending on model) Your steam generator is equipped with a retaining clip which locks the iron on its casing for easier transport and storage – fig.1: • Locking – fig.2 • Unlocking – fig.3 To carry your steam generator by the iron handle: -place the iron on the iron rest of the generator and raise the retaining hoop over the iron until it locks into place (audible click) – fig.2 -grasp the handle of the iron to carry your steam generator – fig.1 Preparation Due to the powerful steam output, a mesh type ironing board must be used to allow any excess steam to escape and to avoid steam venting sideways. What water may be used ? • Your iron has been designed to operate using untreated tap water. If your water is very hard • Heat concentrates the elements contained in water during evaporation. The (check with your local water authority) it is types of water listed below contain organic waste or mineral elements that possible to mix untreated can cause spitting, brown staining or premature wear of the appliance: water tap water with store- from clothes dryers, scented or softened water, water from refrigerators, bought distilled or batteries or air conditioners, pure distilled or demineralised water or rain water demineralised water in the following proportions : should not be used in your iron. Also do not use boiled, filtered or bottled 50% untreated tap water, water. 50% distilled or demineralised water. Filling the water tank • Place your steam generator on a stable, horizontal heat-resistant surface. • Ensure that your steam generator is unplugged and that the soleplate and the iron rest have cooled down. • Open the water tank filler cover– fig.4. • Pour in untreated tap water up to the max mark – fig.5. • Close the water tank filler cover. Using the Easycord system (according to model) • Your iron is equipped with an extension cord system to prevent the cord from dragging over the laundry and creasing it again when ironing. • Take the steam cord out of its housing and unwind it completely. • Remove the tie to release the cord outlet. • Press the Eject button – fig.6 and the Easycord system extends automatically. • When the cord outlet tips, the Easycord system extends automatically without you having to press the Eject button. 5 Using your steam generator The first time the • Completely unwind the power cord and the steam cord from its storage space. appliance is used, there • Lower the retaining hoop (depending on model) to unlock the safety catch – fig.3. may be some fumes and • Plug in your steam generator to an earthed socket. smell but this is • Press on the on / off switch. The green light (located on the control panel) flashes not harmful. They will not and the boiler heats up – fig.7. affect use and will disappear rapidly. When the green “steam ready” light stops flashing (after 2 minutes approxima tely), the appliance is ready. Operating the control panel • Green light flashes: ...
Otros modelos de este manual:Planchas - Express GV7150 (1.12 mb)