Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
The shelf with the heat deflection plate should be positioned in the lower shelf position. 3 Press and turn the control anti-clockwise to Mark 6. 4 While keeping it depressed, press the ignition button to light the burner. 5 Keep the control depressed for 15 seconds after the burner has lit to over-ride the safety device. 6 Close the door. 7 Allow 10 minutes for pre-heating. 8 Set the knob as required or as recommended in the chart. 9 To switch off turn the knob clockwise to the • off position. • If the burner doesn't light the first time, press the ignition button once or twice again. If it still doesn't light, turn off and wait for 1 minute to allow gas to disperse before trying again. • Do not hold the control in for more than 15 seconds. • Ensure you stand back from the appliance when opening the oven door to allow any build up fof steam or heat to escape. • Check food is thoroughly cooked and is piping -it» hot • Do not heat an unopened glass or metal container in the oven. 17 know your cooker Integral air grille Control panel Grill Grill door Oven door Adjustable feet for leveling Oven tray Rating label Some of the illustrated details may vary specification External dimensions width x depth x height 500mm x 600mm x 900mm Front-right rapid burner capacity Nominal rate 2900W Rear-left burner capacity Nominal rate 2000W Rear-right burner capacity Nominal rate 1000W Front-left burner capacity Nominal rate 2000W Supply voltage 230V- 50Hz Oven burner Nominal rate 2500W Grill burner 2000W (adjustable for Natural Gas) Total power (gas) 12400W Gas Supply pressure Destination countries G31 37 mbar G20 20 mbar G25 25 mbar GB GB I 2H AT 20 mbar and 13P AT 37 mbar Cat I 2H3p Because we continually strive to improve our products, we may change our specifications and designs without prior notice. Accuracy Note that times and temperatures in this book are for guidance only. Lamp 15/25 W Ignition Auto electric all burners Safety device Gas valves are lockable 6 \ocat\om ! • The cooker is designed to fit between kitchen cabinets spaced over 500 mm apart. The space either side of the cooker need only be sufficient to allow withdrawal of the cooker for servicing. It can be used with cabinets on one side or both sides as well as in a corner setting. It can also be used free-standing. • Adjacent side walls above the appliance must not be nearer to the cooker than 150mm and should be of heat resistant material. Leave at least 750 mm clearance above the hob. • Excess steam from the oven is expelled at the rear of the appliance therefore the wall behind the cooker needs to be protected against grease and moisture. LP Gas only Do not install this appliance in a room below ground level unless it is open to ground level on at least one side. Failure to install appliances correctly is dangerous and could result in prosecution. /777/7777777777777777777777 ventilation oM A/I Natural ventilation is important for the correct functioning of the appliance and your own safety. Prolonged intensive use of the appliance may call for additional ventilation, for example the opening of a window, or the use of permanent fixed mechanical ventilation system, for example, an extractor fan or cooker hood that ventilates to the outside. Room considerations and built-in ventilation The appliance must not be installed in a room without a window or other controllable opening. If it is installed in a room without a door which opens directly to the outside, a permanent opening is required. The size of the free area of a permanent opening must be as follows: Room volume Opening Up to 5m3 100cm2 5m3 to 10m3 50cm2 Above 10m3 None In cellar or basement 65cm2 These requirements apply for a full cooker equivalent, however if there are other fuel burning appliances in the same room. The regulations in force for the UK should be consulted. 7 operating the grill ? Parts may become hot when the grill is in use, children must be kept away. The door must be kept open during grilling at all times. When the door is fully open, it remains tilted slightly, so that any spillage will be directed away from you. There is a safety device that prevents the build-up of gas inside the cavity if the burner doesn't light or goes out for any reason. 1 Open the grill door. 2 Position the shelf in a suitable position. 3 Press and turn the control anti-clockwise to the large flame symbol. 4 While keeping it depressed, press the ignition button to light the burner. 5 Keep the control depressed for 15 seconds after the burner has lit to over-ride the safety device. 6 Allow the grill to preheat for 5 minutes. 7 The grill can be operated at the max setting or at the lower rate* - adjust by turning the knob to the smaller flame symbol. 8 To switch off turn the knob clockwise to the • off position. • If the burner doesn't light the first time, press the ignition button once or twice ...
Otros modelos de este manual:Placas - DG581 (741.93 kb)