Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
To prevent stains from being burnt on to the grill pan, food support and rod shelf, always wash immediately after use in warm soapy water. Use a well soaped fine steel wool soap pad to remove stubborn stains from the rod shelves, grill/meat pan and the base of the oven. OVEN SHELVES GRILL/ MEAT PAN MAIN OVEN BASE DO NOT use aerosol cleaners on this oven as they could adversely affect the fan motor unit, and cannot be wiped off the fan blade. (c) Speedgrill To clean the Speedgrill, use a clean, damp, soapy cloth and wipe over. If stubborn stains remain, gently clean with a well soaped nylon scouring pad and wipe over with a damp cloth. DO NOT use metal cleaning utensils, wire wool or proprietary oven cleaners on the grill element mesh. Care and Cleaning 3. CONTROL PANEL / TRIMS / INNER DOOR PANEL & GLASS TRIMS (a) Control Panel OVEN DOOR Regularly wipe with a clean, damp cloth and polish with a clean, dry cloth. (b) Trims It is advisable to clean the trims regularly to prevent any build up of soiling which may detract from the appearance of the cooker. The recommended method of cleaning is to wipe over the trims with a clean, soft cloth wrung out in warm water, or mild non abrasive cleaner. (If in doubt try the cleaner on a small area of trim which is not noticeable in normal use), then after wiping with a cloth wrung out in clear water, dry with a clean, soft cloth. (c) Inner Door Panels & Glass Open the door fully. The glass panel may now be washed. Stubborn stains can be removed by using a well soaped, fine steel wool soap pad. DO NOT use scouring pads, or abrasive powder, which will scratch the glass. Open the oven door and remove the oven shelves. Using a thick cloth, grip the lamp lens, unscrew anti- clockwise and remove the lens. Carefully unscrew the bulb anti-clockwise. Fit replacement bulb (15W 300°C SES). Fit replacement bulb and refit lens. 5. HOW TO CLEAN THE LAMP LENS 4. REPLACEMENT OF THE OVEN LAMP MAIN OVEN LAMP Warning: Before removing lamp lens, please ensure that the main cooker wall switch is switched off and the appliance is fully cold. 28 MAIN OVEN LAMP Warning: Before cleaning lamp lens, please ensure that the main cooker wall switch is switched off and the appliance is fully cold. Open the oven door and remove the oven shelves. Using a thick cloth, grip the lamp lens, unscrew anti- clockwise and remove. Clean with a non-abrasive cleansing cream and refit lamp lens. DO NOT use scouring pads, or abrasive powder, which will scratch the glass lens Care and Cleaning Take particular care not to damage the inner surface of the door inner glass that is coated with a heat reflective layer. Do not use scouring pads, or abrasive powder, which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows. Stubborn stains can be removed by using a fine steel wool pad. For slight soiling the inner glass panel may be cleaned, while still warm, without removing it from the door. After cleaning, rinse and dry with a soft cloth. CLEANING THE DOORS SIDE OPENING DOORS Cleaning the door glass is the same as the drop down doors, except take care to support the weight of the inner glass when removing and refitting. DROP DOWN DOORS Remove the door inner glass as follows. 1. Open the door fully and unscrew the two screws securing the glass panel so that the securing brackets can be turned. There is no need to remove the screws completely. 2. Turn the brackets so that the glass can be removed and cleaned at the sink (Fig. 1.) Fig. 1. 3. The inside of the outer door glass can now be cleaned while still fitted to the cooker. Glass NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION. Refit the door inner glass as follows. 1. NOTE: The inner door glass has a special reflective coating on one side. Replace the door inner glass so that the statement: “IMPORTANT THIS FACE TOWARDS THE OVEN” can be read from the inner side of the door. 2. Turn the two securing brackets back to their original position to retain the glass and tighten the screws. (Fig. 2.) Fig. 2. Glass Installation Instructions Important This equipment is designed specifically for domestic purposes and Creda Limited cannot accept responsibility if used in any other type of installation. All Creda oven units are suitable for installation under Creda hob units. This appliance must not be installed over any appliance that generates heat. For your own safety, we recommend that your appliance is installed by a competent person – such as one who is registered with NICEIC (National Inspection Council for Electrical Installation Contracting). The cooker should be installed in accordance with the latest Edition of the IEE Regulations. 1. General WARNING: THIS APPLIANCE MUST BE EARTHED. (a) The oven unit is designed for mounting at a safe level into an oven housing which must be secured to the backing wall, or alternatively, in the case of the single oven unit, under a worktop with or without a hob unit above. (b)...