Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
There are two ways to check the suitability of your cookware: 1. Using a magnet to see if the base of the pan is magnetic: if the magnet sticks, then the cookware is compatible. 2. Place the pan on one of the cooking zones switched on to power level 4: if the display remains on, then the cookware is compatible. If the display flashes, the cookware cannot be used on an induction hob. Using your Hob Fig.1 21436578 Zones: 1. Front left 2.3 kW 210 mm 2. Back left 2.3 kW 180 mm 3. Back right 2.3 kW 210 mm 4. Front right 2 kW 160 mm Control panel: 5. Zone control keys and display 6. Timer control keys 7. Timer display 8. Childlock key The table below offers guidance as to what each power level is for. Switch position Type of cooking 0 Switched off 1/2 For melting (butter/chocolate) or keeping food warm 2/3 Keeping food hot or to heat small quantities of liquid 3/4 Heat larger quantities of liquid (sauces etc.) 4/5 Slow boiling, e.g spaghetti, soups, stews, potatoes 6/7 Gentle frying 7/8 Browning meats, frying fish, omelettes 9 Fast frying steaks Using your Hob Please note: • A dot will show on either the zone control display or the timer display to demonstrate which is the active control. To select a different control, touch either the required zone control key or the timer key. To switch the zone on • Touch the zone control key for the required zone. The zone control display will flash with 0 and . for the relevant zone and the hob will beep to confirm the zone is on. To set the power level • Touch the + key to increase the power level from 1 (lowest) to P (maximum) and the – key to reduce it. • To go straight to P, touch the – key once when the zone is switched on. Please note: • If a power level is not set within five seconds, the zone will switch off automatically. To switch the zone off • Touch and hold the zone control key for the required zone until the display switches off. The timer • The timer allows you to preset the length of time any of the zones will be on, between a minimum of one minute and a maximum of ninety-nine minutes. The timer can be used on each zone separately. To set the timer • First switch on the zone and set the power level. • Touch the timer key repeatedly until the LED in the timer display is lit for the required zone. • Then touch the + and – keys until the timer display shows the required duration. • To go straight to the maximum 99 minutes, touch the – key once when the timer is switched on. Please note: • The timer will only count down when the cookware is on the zone. • The timer will count down in minutes, and then in seconds for the last minute. • At the end of the set time, the zone will switch off, the timer display will flash 0 and the hob will beep for approximately 20 seconds. To stop the beep, touch any key. To change the timer once set • Touch the timer key repeatedly until the LED is lit for the required zone. • Then touch the + and – keys until the display shows the required duration. To cancel the timer once set • Touch the timer key repeatedly until the LED is lit for the required zone. • Then touch and hold the + and – keys simultaneously for approximately three seconds. This will cancel the timer. Please note: • If you cancel the timer, the zone will continue at the set power level until it switched off as described above. The childlock The hob is equipped with a childlock to lock the controls. This can be used when the hob is off or during cooking. To set the childlock • Touch the childlock key for approximately three seconds until the LED above the childlock key illuminates and the hob beeps to confirm the childlock is switched on. To turn off the childlock • Touch the childlock key for approximately three seconds until the LED above the childlock key goes out and the hob beeps twice to confirm the childlock is switched off. Use of the childlock when the hob is off • The childlock LED will illuminate briefly when any zone control key is touched. Use of the childlock when the hob is in use • The zone control display will alternate between showing the selected power level and the locked symbol for any zone in use. • For any zone not in use, the display will show the . locked symbol, the hob will beep and the childlock LED will illuminate briefly when the control keys are touched. • It is possible to switch off a zone when the childlock is on for safety reasons. Residual Heat Indicators The hob is equipped with residual heat indicators to warn when any of the zones are still hot to the touch after cooking. An H will flash in the relevant zone display after cooking until the zone is at a safe temperature to touch. Please note: • You should avoid touching the zones when the hob is in use, or when an H is showing on the zone display. • In the event of a power cut, the residual heat indicators will illuminate after the power supply is restored. However, when there is no power supply to the hob the residual heat indicators will not work, so extra care must be taken. Te...