Votos - 2, Puntuación media: 4.5 ( )

Fabricar: Kenmore Tamaño del archivo: 2.08 mb Nombre del archivo: Idioma del manual:

To Clean the Removable Burner Base and Gas Opening (some models) The ports (or slots) around the burner base must be routinely cleaned. Use a small-gauge wire or needle to clean small slots or holes. Note: If the electrode is damaged or broken, the surface burner will not light because it will not spark. Manual lighting with a match is still possible. For proper flow of gas and ignition of the burner -DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING TUBE. Gas must flow freely through the small hole in the brass orifice for the burners to light properly. If the gas opening orifice becomes soiled or clogged, use a small-gauge or needle to clean. ALWAYS keep the burner cap in place whenever a surface burner is in use. To Replace the Burner Base and the Burner Cap Make sure the pieces are thoroughly dry before placing back. 1. Replace burner base and burner cap in their places. Make sure each burner cap and burner base are properly aligned and leveled. 2. Replace the burner grate. 3. Turn the burner on to determine if it lights, if the burner does not light after cleaning, contact a Sears or other qualified service dealer. Do not service the sealed burner yourself. !iI................... ........... ii....... 13 Before You Call Solutions to Common Problems Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. OCCURRENCE POSSIBLE CAUSE/SOLUTION Surface burners do not light. Surface Control knob has not been completely turned to LITE. Push in and turn the Surface Control knob to LITE until burner ignites and then turn control to desired flame size. Be sure gas supply valve is open. Gas-air mixture needs a straight line to travel. Be sure burner is properly seated in its support (models with open burners only). Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to clean ports or slots. Power cord is disconnected from outlet (electric ignition models). Be sure cord is plugged securely into outlet. Electrical power outage (electric ignition models). Burners can be lit manually. See Setting Surface Controls in this Use & Care Guide. Surface burner flame burns half way Burner ports or slots are clogged. With the burner off, clean ports with a small- around. gauge wire or needle to clean ports or slots. Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full. To avoid this occurrence dry the burners thoroughly following instructions under General Care & Cleaning. Surface burner flame is orange. Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue. In coastal areas, a slightly orange flame is unavoidable due to salt air. 14 PROTECTION AGREEMENTS Master Protection Agreements Congratulations on making a smart purchase. Your new Kenmordeproduct ...

Descargar ahora

Introduzca dos números de la imagen: