Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
The warranty will only be valid if the appliance is used for the purpose for which it was designed. The place in which the appliance is installed must have fully-functioning ventilation, in accordance with the regulations. Do not subject the appliance to draughts. These might blow out the burners. This appliance leaves the factory set to the type of gas that is indicated on the specifications plate. If this must be changed, read the Assembly instructions. Do not tamper with the appliance's interior. If necessary, call our Technical Assistance Service. These operating and installation instructions should be retained, and passed onto the buyer if the appliance is sold. Do not switch on the appliance if it is damaged in any way. Contact our Technical Assistance Service. The surfaces of cooking appliances heat up during use. Care must be taken when using these appliances. Keep children well away from this appliance. This appliance is only intended for cooking purposes, not as a heating system. Fat or oil which is overheated can catch fire easily. Do not leave oil or fats to heat up unattended. If oil or fats do catch fire, never use water to put the fire out. Risk of burns! Put the fire out by covering the pan with a lid and switch off the hotplate. In the event of a malfunction, turn off the appliance’s gas and electricity supply. For repairs, call our Technical Assistance Service. If one of the control knobs will not turn, do not force it. Call the Technical Assistance Service immediately, so that they can repair or replace it. Never place unstable pans on the hob or the burners, as they may accidentally tip over. Do not clean the hob using a steam cleaner. Risk of electrocution! This appliance is class 3 type, according to the EN 30-1-1 standard for gas appliances: built-in appliance. Do not store or use corrosive chemicals, steamers, flammable materials or non-food products below or near this domestic appliance. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Never leave the appliance unattended during operation. The graphics in this instruction manual are given as a guide only. The manufacturer is exempt from all responsibility if the requirements of this manual are not complied with. Your new appliance 31 5 4 4 2 1 Pan supports 2 Control knobs 3 Auxiliary burner (up to 1,1 kW) 4 Semi-rapid burner (up to 1,9 kW) 5 Rapid burner (up to 2,8 kW) Gas burners Operation . Fig. 1 Fig. 2 Switching on manually Switching on automatically There are indications to show which burner each control knob operates. Fig. 1. It is essential to ensure that all the burner parts and pan supports are correctly installed for the appliance to work correctly. Fig. 2-3. Fig. 3 1. Press the chosen burner control knob and turn it anticlockwise to the required setting. 2. Use any type of lighter or flame (cigarette lighter, matches, etc.) and bring it close to the burner. If your hob can be switched on automatically (ignition sparkers): 1. Press the chosen burner control knob and turn it anticlockwise to the maximum power setting. While the control knob is still pressed down, sparks are produced on all burners. The flame ignites (it is no longer necessary to press down the control knob). 2. Turn the control knob to the required setting. If it does not come on, turn the control knob to the off setting and repeat the steps above. This time, press and hold the control knob for longer (up to 10 seconds). Warning! If after 15 seconds the flame does not ignite, switch off the burner and open a nearby window or door. Wait at least one minute before trying to switch the burner on. Safety system Depending on the model, your hob may have a safety system (thermocouple) that prevents the flow of gas if the burners accidentally switch off. To ensure that this device is active, switch on the burner as usual and, without releasing the control knob, press and hold it down firmly for 4 seconds after lighting the flame. Thermocouple Ignition sparker Switching off a burner Turn the corresponding control knob clockwise to the 0 setting. Los mandos progresivos le permiten regular la potencia Power levels que necesite entre los niveles maximo y minimo. Control knob Setting off Maximum capacity or High aperture and flame electricity on Minimum Low capacity or flame aperture Warnings It is normal to hear a slight whistling noise while the burner is operating. When it is first used, it is normal for the burner to give off odours; this does not pose any risk and does not indicate a malfunction; they will disappear in time. A few seconds after the burner is switched off, a sound (thud) will be produced. This is not a fault - this means that the safety device is no longer operating. Keep the burner as clean as possible. If th...
Otros modelos de este manual:Placas - GK41TG/07 (966.18 kb)