Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
GREEN/YELLOW: EARTH BLUE: NEUTRAL BROWN: LIVE Connect the Green/Yellow wire to the terminal marked E or the earth symbol or coloured Green or Green/Yellow. Connect the Brown wire to the terminal marked L or coloured Red. Connect the Blue wire to the terminal marked N or coloured Black. DO NOT connect the Brown (Live) or the Blue (Neutral) wires to the Earth terminal of your 13 amp plug. If the terminals of the plug are unmarked or you are in any doubt, consult a qualified electrician. CAUTION: If you use this heater in conjunction with a thermal control, programme controller, timer or any other device which switches the heater on automatically observe all safety warnings at all times. Positioning the Heater Select the position for the heater ensuring there is clearance from any furniture and fittings of at least 150mm above the heater, 50mm below (wall mounted) and 25mm each side. Curtains must not be closer than 150mm from the top of the heater. Free Standing Operation (see Fig. 1) NEVER USE THE HEATER FREE STANDING WITHOUT THE FEET FITTED (FEETARE PACKED SEPARATELY IN CARTON). 1. Lay the heater on its front. 2. Remove the two socket head screws from the base of the heater using the hexagon key supplied. 3. Place feet over base of heater, align holes and engage hook on foot into the recess on the back of the heater see Fig. 1. 4. Replace the screws but do not overtighten. Fig. 1 Rear View Installation The Fixing Kit should contain: 1 Drilling Template, 3 Screws, 3 Rawlplugs, 1 Mounting Bracket and 1 Hexagon Key. Wall Mounted Operation (see Fig. 2) Suggested Fixings SOLID BRICK/BLOCK: No. 8 Rawlplug inserts, 6mm drill bit. PLASTERBOARD: If possible locate studding and use No. 8 woodscrews directly into the wood, otherwise M5 rawlplug intersets are suitable. NOTE: FOR OTHER WALL TYPES (e.g. Timber frame and hollow concrete) SEEK SPECIALIST ADVICE. 1. Select the position for the heater ensuring there is clearance from any furniture and fittings of at least 150mm above the heater, 50mm below and 25mm each side. Curtains must not be closer than 150mm from the top of theheater. 2. Position the drilling template provided on the wall ensuring it is level. Mark the position of the relevant holes on the wall at the edge of template. Before drilling check that the distance between the hole centres is correct, 340mm for 400W Models and 540mm for 800W models (see Fig. 2). 130mm 340mm - 400W 540mm - 800W 95mm 150mm 50mm 420mm25mm 25mm 130mm Drilling Holes Bracket Fig. 2 3. Drill the wall at the three marked positions and fit the wall plugs. Ensure template has been removed. 4. Fix two No. 8 screws to the top two holes leaving 3mm of the screw exposed. Hang the heater on the screws. 5. Fit the bottom bracket, found in the fixing kit, in the slot at the base of the heater and screw the bracket to the wall. Test that the heater is now securely fixed to the wall. Operation IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER. Before using the heater ...
Otros modelos de este manual:Los aficionados - DXLWP400 (200.08 kb)
Los aficionados - DXLWP400TI (200.08 kb)
Los aficionados - DXLWP800 (200.08 kb)
Los aficionados - DXLWP800TI N (200.08 kb)