Votos - 0, Puntuación media: 5 ( )

Fabricar: Air King Tamaño del archivo: 349.84 kb Nombre del archivo: 6160500EN.pdf Idioma del manual:

5 Maintenance and cleaning Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Cleaning the grease filters Clean the filter every month or every other month according to how much the hood is used. The cleaner the filters, the more grease they collect. Remove the filters by (Fig. 3): l Push the handle towards the rear of the hood. l Pull the filter down at the front and remove it forwards. The filter is made of aluminium wires on which the grease collects. Clean the filter in hot water using a detergent, or in a dishwasher. Let the filter dry before putting it back. Note that a dishwasher may discolour the filter. Changing and cleaning the carbon filter Only applicable for recirculation. The carbon filters absorb smells and odours. Unlike other carbon filters, the LONGLIFE KF8 carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100. C. Fig. 3 The KFL 60/80 carbon filter can not be reactivated, it has to be changed after 6-8 months of normal use. 6 Changing the light Disconnect the cooker hood from the main supply before changing the light. To change the light (Fig. 5): l Remove the the glass diffuser. l Replace the old bulb with a new one of the same type. l Refit the glass diffuser. After approximately three years of use, the KF8 filter should be replaced with a new, as the odour reduction capacity will be reduced. To remove the filter (Fig. 4): l Remove the grease filters. l Press the red buttons (A), lower the front of the carbon filter. l Remove the carbon filter. l Replace in reverse order. Fig. 5 Fig. 4 Clean the filters regularly. The grease that collects in the filters and the duct could ignite if a hot plate is left on (or if overheating occurs). What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working effectively... The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation... The safety cut-out service h...

Descargar ahora

Introduzca dos números de la imagen: