Iniciar sesión:
Votos - 6, Puntuación media: 4.7 ( )

Manual de usuario Tamarack Technologies, modelo HV1000

Fabricar: Tamarack Technologies
Tamaño del archivo: 799.98 kb
Nombre del archivo: 765fea3e-f756-4292-81e1-f1202c1b4dc7.pdf
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


HV1000 -The HV1000 is operated by the wall switch (not included) installed per the wiring instructions. An optional remote control kit is available (Part# TTi-HVRC). HV1600 -The HV1600 is controlled by the hand held remote transmitter. Additional controls, when used, may override the remote control. See the Wiring section of this manual for further details. Care All the motors in the HV are permanently sealed and do not require oiling. To keep dirt, dust and debris from the fans we recommend that you periodically remove the grille from within the living space and dust the fan blades. Please remember to make sure that the fan is OFF before dusting the fan blades. Troubleshooting HV1000: The most common problem with the HV1000 is caused by incorrect wiring. Before you check anything else make sure: WHITE wire in HV1000 is connected to 115 VAC Line Neutral; RED wire in HV1000 is connected to 115 VAC Line Hot (Constant Hot Feed); BLACK wire in HV1000 is connected to a switch that will make it hot when the switch is closed. HV1600: If the wireless remote fails to activate the fan, the battery may need replacing. The transmitter uses a type A23/12V battery. Remove the back plate from the transmitter and remove the battery. Following the markings, replace the battery. Secure the back plate to the transmitter. Re-programming the HV1600 Remote • Remove the cover from the control box • Push the B w#1 button on the side of receiver for 3 seconds…the Green LED light will flash quickly • While the Green LED is flashing push the “1” button on the transmitter. the Green LED light will flash. this programs ON/OFF • Push the R d#2 on the side of the receiver for 3 seconds…the Red LED light will flash quickly • While the Red LED is flashing push the “2” button on the transmitter. the Red LED light will flash. this programs HI/LO • Replace the cover on the control box Switch Doors Fans Possible Cause Try On Do Not Open Do Not Run No Power Check connections and circuit breakers On (audible “click”) Do Not Open Do Not Run No constant power on Red Check wiring connections. There must be constant power on the red wire. Off Do Not Close Stop RED and BLACK are connected together. Check wiring connections. Connections at the fan must be made individually. On Both Open One Fan Runs Something blocking fan rotation Turn the power off and check for foreign matter blocking blade rotation. On Both Open -One closes then opens... One Fan Runs Door motor gears or switch may have been stressed during installation. Framing opening may be too small. Remove fan from between joists and test operation while fan is sitting on top of joists. If the fan operates, enlarge the opening and return the fan to installed position. Off Both Closed One opens then closes... Stop Door motor gears or switch may have been stressed during installation. Framing opening may be too small. Remove fan from between joists and test operation while fan is sitting on top of joists. If the fan operates, enlarge the opening and return the fan to installed position If for some reason the lift arm becomes detached from the door bracket it can easily be re-attached. Inspect the pin for damage and replace if necessary. Cycle the whole house fan until the doors are in the open position. Support the door and simply push the lift arm over the tapered end of the pin. LIMITED WARRANTY If, within the period of three years from the date of purchase, the HV 1000 or HV 1600 (the Product) is defective or malfunctions in normal home use, Tamarack Technologies, Inc. will repair or replace the Product, at its discretion. Customer is responsible for shipping charges. NOTE: Some states codes require fans to be hardwired. Hardwiring of the HV1600 will not void warranty provided the wiring is performed by a licensed electrician. CONDITIONS, EXCLUSIONS, AND LIMITATIONS -This Warranty is subject to the following conditions, exclusions and limitations: THIS WARRANTY DOES NOT COVER PROBLEMS RESULTING FROM INSTALLATION, OPERATION OR MAINTENANCE THAT HAS BEEN UNDERTAKEN OTHER THAN IN ACCORDANCE WITH THE INSTRUCTIONS. THIS WARRANTY DOES NOT COVER PROBLEMS RESULTING FROM DEFECTS IN OR CAUSED BY ASSOCIATED EQUIPMENT (FURNACES, SOLARIA, ETC.); FROM REPAIRS OR MODIFICATIONS ATTEMPTED BY PERSONS OTHER THAN TAMARACK TECHNOLOGIES, INC.; FROM ABUSE, ACCIDENTAL OR SHIPPING DAMAGE OR ACTS OF GOD. THIS WARRANTY DOES NOT APPLY TO THE PRODUCT USED OUTSIDE THE UNITED STATES, ITS TERRITORIAL POSSESSIONS, AND CANADA. EXCEPT AS SET FORTH ABOVE, NO EXPRESS OR IMPLIED WARRANTY IS GIVEN OR AUTHORIZED BY TAMARACK TECHNOLOGIES, INC. AND ALL OTHER SUCH WARRANTIES ARE EXPRESSLY DISCLAIMED. ANY WARRANTY OR MERCHANTABILITY OF FITNESS FOR ANY PARTICULAR PURPOSE SHALL BE LIMITED TO THE WARRANTY HEREUNDER. MOREOVER, ANY LIABILITY OF TAMARACK TECHNOLOGIES, INC. FOR THE PRODUCT SHALL BE LIMITED TO THE REPLACEMENT VALUE OF THE PRODUCT. IN NO EVENT SHALL TAMARACK TECHNOLOGIES, INC. BE LIABLE FOR ANY INCIDENTAL DAMAGES OR FOR ANY CONSE...

Otros modelos de este manual:
Los aficionados - HV1600 (799.98 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría