Votos - 2, Puntuación media: 3.5 ( )

Fabricar: Fisher & Paykel Tamaño del archivo: 187.59 kb Nombre del archivo: Idioma del manual:

• To comply to electrical safety regulations this canopy must be plugged into a socket near the appliance. The socket must be accessible and enable the end user to isolate the canopy from the power for the purpose of internal cleaning or maintenance. Ducting accessories are not supplied. All ducting must comply with local requirements and building codes. The canopy hood is heavy please ensure adequate care when installing the canopy hood to prevent personal injury. The canopy hood must be installed onto a solid wall or solid stud. Weight of product 43.2 kg. HEIGHT OF CANOPY HOOD • The canopy is designed for 2440mm high ceilings. • The chimney is telescopic and is designed for hood installations between 600 to 750mm above the cooking surface. • Ascertain the desired installation height of the canopy hood. • Any installation above 750mm will compromise the extraction performance. • The air outlet from the motor requires 150mm round ducting which requires 170mm diameter hole in the ceiling. A=600 min (electric cook top) A=650 min (gas cook top) CONTROL PANEL Delay switch: Canopy hood will remain on a low, mid or high speed for five minutes to clear away all residual cooking odours before switching off automatically. FILTER SURFACE HOB TOP A 2 2 3 5 6 7 8 9 10 4 PLAN VIEW OF SUPPORT FRAME FRONT FACE OF CANOPY INSTALLATION - DUCTED Before drilling any holes check that the area behind the surface to be drilled is clear of any electrical cables, pipes etc. Fixing to a solid joist or 50mm deep truss is recommended. Whenever possible protect the hob top with cardboard or the like. 1. Before commencement unpack the canopy hood and check that it functions correctly. 2. Use a plumb line to mark the centre of the cooking surface on the ceiling. 3. Using the ceiling bracket as a template mark the four holes on the ceiling. Ensure that the ceiling bracket front edge is parallel with the bench top and that the plumb line mark is central to the four mounting screw holes. 4. Drill holes in the ceiling at the points marked. a. When fitting to a 50mm truss drill a pilot hole through the ceiling and into the truss. b. If securing to any other ceiling type please use appropriate fasteners and follow their instructions of use carefully. 5. For the ducting mark out and cut a O170mm hole in the ceiling. 6. Fix the ceiling bracket to the ceiling using the screws supplied. 7. Using duct tape secure the ducting to the top of the motor housing. Solid ducting, galvanized or plastic is recommended. Use flexi ducting only in difficult installations and if used ensure that it is pulled tight. The smoother, straighter and shorter the ducting the quieter and more efficient the canopy hood will perform. Tape the power plug to the top of the ducting, this will enable easy access to the plug after installation. 8. Mount the first set of four angle brackets on the canopy. Use eight self tapping screws, one per side per corner. 9. Determine the installed height of the canopy and attach the second set of four angle brackets to the first to achieve this hei...

Descargar ahora

Introduzca dos números de la imagen: