Votos - 3, Puntuación media: 3
(
)
)
|
Resumen del manual
• Since the rule for rooms with fuel burning appliances is “outlet hole of the same size as the ventilation hole”, a hole of 500-600 cm2, which is to say a larger hole, could reduce the performance of the extractor hood. • If the hood is used in its recirculation function, it will operate simply and safely in the above conditions without the need for any of the aforementioned measures. • When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: — short and straight outlet hose — keep bends in outlet hose to a minimum — never install the hoses with an acute angle, they must always follow a gentle curve. — keep the hose as large as possible (preferably the same diameter as the outlet hole). • Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the extractor hood. Description of the Appliance • The hood is supplied as an extractor unit and can also be used in a recirculation mode by fitting one charcoal filter (available from your local Service Force Centre). Extractor version • In this version fumes are extracted to the outside via a hose. • In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Recirculation Version • The air is filtered through a charcoal filter and returned to the kitchen. • You will need an original AEG charcoal filter for the recirculation function. (Available from your local Service Force Centre). Fig. 1 A = ON/OFF switches (Motor, light) B = Grease filter C = Light D = Control panel E = Visor (Removable) Control Panel • The switches are mounted on the upper right side of the visor (Fig. 1 -E). The numbers and symbols have the following meanings (from left to right): DF 6260 - CHDF 6260 DF 6160 -DF 6260-ml/1 1 = fan set 1 = Continuously variable fan control 2 = fan set 2 3 = fan set 3 = Intensive setting 4 = fan set 4 = Light = Light = Light OFF = Light OFF = Light ON = Light ON The fan is controlled by moving the sliding switch. The extractor part (visor) of the hood is used to switch the fan on and off when the appliance is switched on (Motor). When the visor of the appliance is withdrawn, the fan automatically switches on. If the visor is pushed in without operating the switches, the fan is switched off. The lighting can be separately switched on and off with the slide switch. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared. Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. • Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. • Only ever clean the switch panel and filter grille using a damp cloth and de...
Otros modelos de este manual:Los aficionados - COOKER HOOD CHDF 6260 (613.74 kb)
Los aficionados - COOKER HOOD DF 6160 (613.74 kb)
Los aficionados - COOKER HOOD DF 6160 (613.74 kb)
Los aficionados - COOKER HOOD CHDF 6260 (613.74 kb)