Votos - 3, Puntuación media: 4.3
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
.Slide the opening/closing switch to open/close the cover. 12 13 14 14 Internal stereo microphones 15 1617 18 1920 21 15 Menu button [MENU] (l40) 16 Status indicator (l27) 17 Mode switch (l28) 18 Recording start/stop button (l32) 19 Cursor button (l37, 40, 50) . Use the cursor button to select the recording functions and playback operations, and to operate the menu screen. . In this owner’s manual, the cursor button is denoted as shown below or as 3/4/2/ 1. Example: For pressing the (down) button or Press 4 20 Enter button [ENTER] (l37, 40, 50) 21 Battery holder (l20) VQT4C31 22 Battery release lever [BATTERY] (l20) 23 Tripod receptacle . If you attach a tripod which has a 5.5 mm (0.22 q) screw or larger, it may damage this unit. 22 23 27 28 24 Photoshot button [ ] (l34) 25 Zoom lever [W/T] (In Recording 24 2526 Mode) (l48) Thumbnail display switch [ / ]/ Volume lever [sVOLr] (In Playback Mode) (l38) 26 Speaker 27 Grip belt Adjust the length of the grip belt so that it fits your hand. . .. 1 Flip the belt. 2 Adjust the length. 3 Replace the belt. 28 HDMI mini connector (l72, 75) VQT4C31 Preparation Power supply Preparation Power supply . About batteries that you can use with this unit The battery that can be used with this unit is VW-VBL090/VW-VBK180/VW-VBK360. It has been found that counterfeit battery packs which look very similar to the genuine product are made available to purchase in some markets. Some of these battery packs are not adequately protected with internal protection to meet the requirements of appropriate safety standards. There is a possibility that these battery packs may lead to fire or explosion. Please be advised that we are not liable for any accident or failure occurring as a result of use of a counterfeit battery pack. To ensure that safe products are used we would recommend that a genuine Panasonic battery pack is used. Inserting/removing the battery . Press the power button to turn off the unit. (l27) Install the battery by inserting it in the direction shown in the figure. Removing the battery Be sure to hold down the power button until the status indicator goes off. Then remove the battery while supporting the unit to prevent it from dropping. Move the battery release lever in the direction indicated by the arrow and remove the battery when unlocked. BATTERY Insert the battery until it clicks and locks. VQT4C31 Charging the battery When this unit is purchased, the battery is not charged. Charge the battery fully before using this unit for the first time. . Charging with an AC adaptor. The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet. Important: . Be sure to use the supplied AC adaptor and USB cable. Do not use parts supplied with other equipment. . The AC adaptor and USB cable are for use with this unit only. Do not use them with other equipment. Similarly, do not use AC adaptors and USB cables from other equipment with this unit. . The battery can also be charged using a battery charger (VW-BC10PP: optional). . The battery cannot be charged when the power is on. Press the power button to turn off the power. (l27) . It is recommended to charge the battery in a temperature between 10 oC and 30 oC (50 oF and 86 oF). (The battery temperature should also be the same.) . . . . . . . A USB terminal B To the AC outlet . Insert the plugs as far as they will go. 1 Open the LCD monitor. 2 Connect the USB cable to the AC adaptor. . Check that the plug portion of the AC adaptor is not loose or misaligned. . Do not use any other AC adaptors except the supplied one. . Do not use any other USB cables except the supplied one. (Operation is not guaranteed with any other USB cables.) 3 Plug the AC adaptor into the AC outlet. 4 Connect the USB cable to the unit. . The status indicator C will flash red for approx. a 2 second time period (off for approx. 1 second, on for approx. 1 second), indicating that charging has begun. It will turn off when the charging is completed. VQT4C31 . Connecting to the AC outlet If you turn on the unit while connecting with the AC adaptor, you can use the unit with power supplied from the outlet. When recording for a long time, keep the AC adaptor connected and use it together with the battery. . Connecting to a PC and charging. Charge the unit if you do not have the AC adaptor handy. . . A USB cable (supplied) . Insert the plugs as far as they will go. . Press the power button and turn the power off. (l27) 1 Turn the power of the PC on. 2 Connect the USB cable. . The status indicator B will flash red for approx. a 2 second time period (off for approx. 1 second, on for approx. 1 second), indicating that charging has begun. It will turn off when the charging is completed. . Do not use any other USB cables except the supplied one. (Operation is not guaranteed with any other USB cables.) . Always connect directly to a PC. . You cannot charge when the ...