Votos - , Puntuación media:
(
)
)
Fabricar: Panasonic
Tamaño del archivo: 1.24 mb
Nombre del archivo: PVD300.PDF
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
Please call 1-800-8-BATTERY for information on how to recycle this battery. 11 Supplying Power AC Adaptor — DC Power Cable POWER Lamp DC IN A, t* VCR DC OUT Connector CAUTION: Connect AC Adaptor VCR DC OUT to Camcorder DC IN with supplied DC Power Cable. Plug in AC Adaptor. POWER Lamp lights. Notes: • AC Adaptor cannot power Camcorder while charging Battery. • When not in use, unplug AC Adaptor from AC outlet. {Adaptor uses 1.2 W of electricity while plugged in.) This unit will operate on 110/120/220/240 V AC. An AC plug adaptor may be required for voltages other than 120 V AC. Please contact either a local or foreign electrical parts distributor for assistance in selecting an alternate AC plug. We recommend using the accessory power plug adaptor (VJSS0070) in an area which has special AC outlets. Car Battery Cord (Optional) DC IN Connector Cigarette Lighter Socket (12 V) Car Battery Cord (optional) Cigarette Lighter Plug 1 Connect PV-C16 Car Battery Cord (optional) to Camcorder DC IN. ^ A Start engine first. B Plug Car Battery Cord into Cigarette lighter socket. • If Car Battery cord fuse needs replacing, use exact current rating (in amps). Notes: • This cord only works in vehicles equipped with DC 12 V (negative ground) battery. Check with your car/truck dealer. Use only specified car battery cord. • To avoid blowing the car battery cord fuse, do step 2 in the proper order. • Running vehicles must be well ventilated • When not in use, disconnect cigarette lighter plug. 12 For assistance, call 1-800-211-PANA(7262) Cassette Information Cassette Insertion/Removal Record/Playback Time Use tapes with the viiss mark in this unit. Turn Tape Wheel in direction of arrow until there is no slack. Attach Battery (page 10). Slide TAPE EJECT to open door. Insert cassette as shown. Press here to close door. • To remove the cassette, slide the TAPE EJECT switch. TAPE SPEED Selector Tape Speed Selector Position Cassette type TC-20 TC-30 TC-40 SP (Standard Play) 20 minutes 30 minutes 40 minutes SLP (Super Long Play) 1 hour 1 hour 30 minutes 2 hours SLP playback may contain more picture noise. Erase Protection Tab A record tab ensures recordings are not accidentally erased. 1 2 To prevent erasure, break off tab with screwdriver. {Or, slide tab open.) To record again, cover hole with adhesive tape. (Or, slide tab closed.) 13 Attaching Shoulder Strap Remove Battery Pack before doing steps; 1 Undo strap ends from buckles. Thread strap ends through Strap Rings on Camcorder. © © min. 25.4mm (1 inch) Re-insert the strap ends into buckles. Adjusting the Length 1 2 Pull a loop of strap from buckle. Pull strap tight to shorten or lengthen. Hand Strap Adjust Hand Strap length to fit your hand as shown. 14 For assistance, call 1-800-211-PANA(7262) MENU Mode Using MENU Mode Before you begin... • Connect Camcorder to power source. • Set POWER to CAMERA or VCR. 1 Press MENU for MENU mode. TITLE ; AUTOrtAANUAL TALLY LAMP ; ON STAND-BY RELEASE ; OFF CLOCK SET ▼ SELECT : PUSH ▼/* KEY SET : PUSH DISPLAY KEY END : PUSH MENU KEY CAMERA MODE - - - MENU - - - DISPLAY SELECT SET END 2Ü ; ON PUSH ▼/A KEY PUSH C*SF\AY KEY PUSH MENU KEY VCR MODE Press UP A or DOWN T to highlight a menu item. Select a desired item. 3 4 Press DISPLAY to set selection. Press MENU to exit. Note: • The Menu mode is canceled if UP/ DOWNfA/TL DISPLAY, or MENU are not pressed within 5 minutes when Self Demo mode is off. • The Menu mode is canceled if UP/ DOWNfA/m. DISPLAY, or MENU are not pressed within 30 seconds minutes when Self Demo mode is on. 15 MENU Mode MENU Mode Screen (CAMERA MODE 1 2 3-1-4 5^ ---MENU--- PAGE 1/2 PROGRAMMED REC TITLE ; AUTO/MANUAL TALLY LAMP ; ON STAND-BY RELEASE ; OFF CLOCK SET SELECT SET END PUSH T/A KEY PUSH DISPLAY KEY PUSH MENU KEY I PAGE 2/2 ▲ DISPLAY ; ON SELF DEMO ; OFF SECURITY ; OFF VIDEO EFFECTS ; FADE BLACK SELECT SET END PUSH T/A KEY PUSH DISPLAY KEY PUSH MENU KEY 1 PROGRAMMED REC (page 24). Camcorder starts and stops recording at a preset time. 2 TITLE (pages 38-40). AUTO/MANUAL : 16 items PHRASE : 10 items 3 TALLY LAMP (page 32). ON: lamp lights during recording. 4 STAND-BY RELEASE (page 22). ON: enables quick resumption of recording from Stand-by mode. 5 CLOCK SET (pages 17-19). Select to set clock. 6 DISPLAY (page 41) ON: On-screen Display (OSD) screens are displayed. 7 SELF DEMO (page 7) ON: SELF DEMO screen is displayed. 8 SECURITY (page 37). ON: enables Motion Security recording. 9 VIDEO EFFECTS (pages 33, 34). AUTO FADE : BLACK or WHITE DIGITAL FADE : TYPE -» 7 types COLOR -» 8 colors MENU Mode Screen (VCR MODE i - - - MENU - - - CLOCK SET • DISPLAY ; ON SELECT: PUSH T/A KEY SET : PUSH DISPLAY KEY END : PUSH MENU KEY 16 For assistance, call 1-800-211-PANA(7262) Setting the Clock Set the following items in order: Time Zone, Setting the Time Zone The Camcorder is preset to Ea...