Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Adjust the level so that the needle of the level meter indicates as below. Normal Audio: Hi-Fi Position Hi-Fi Audio: Hi-Fi Position •Supply normal sound and check that the needle of the level meter does not exceed the “0” position. •Dolby NR Level: The Dolby NR level is located at the “—6” position. Q Audio Input Level Control (CH1/CH2) These controls are used to adjust the audio input level while monitoring the Audio Meter AG-AM10 (option) or Audio Meter Unit AG-AM20 (option). O Tape Run Lamp Lights: During FF or REW mode. Flashes: During cassette tape with CTL signal is running. Q Record Lamp Lights: Recording mode Flashes: No signal is input in the recording mode, or when the “Rec Auto Off” (internal switch) is turned ON. Q Eject/Auto OFF Lamp Lights: No cassette is inserted Flashes: Malfunction has occured to the tape transport system. The unit will not operate. O Mode Indicator Lamps VIDEO AGC: Lights when the “Video AGO (Automatic Gain Control)” is turned ON. Hi-Fi: Lights when the “Hi-Fi Audio Recording” is turned ON. LIMITER: Lights when the "Audio Limiter” is turned ON. DOLBY NR: Lights when the “Dolby NR” is turned ON. O Eject Button Q Test Terminals An oscilloscope can be connected to these terminals for confirmation of Video and Hi-Fi Audio RF output during playback, as well as Phase Generator and Drop Out Compensation. ® To Meter Unit Connector To confirm the audio recording meter level, connect the Audio Meter Unit AG-AM20 (option). 0 Remote Control Connector Exclusively for the Remote Controller AG-A11 (option). ©To Changer Connector Connect the VTR Connector of the Cassette Auto Changer AG-CL78 or AG-CL68 (option). Pin No. Signal Pin No. Signal 1 +20 V Output 6 AUTO OFF Output 2 +5 V Output 3 GND 7 EJECT SW (1) 4 CAS IN Output 8 EJECT SW (2) 5 CAS OUT Output 9 START Output © Hour Meter Indicates the head rotation time (maximum 5000 hours). © Remote Control Connector (34P) Connect to the Remote Controller AG-A600 (option). Pin No. 9-11 12 13-17 18 Signal REC SWITCH PLAY SWITCH FF SWITCH REW SWITCH STOP SWITCH PAUSE SWITCH CASSETTE IN GND REEL PULSE Pin No. 19—20 21 22 23 24 25 26 27 28 29 30-33 34 Signal EJECT SWITCH REC HOLD PLAY HOLD FF HOLD REW HOLD STOP HOLD PAUSE HOLD +12 V (Max. 100 mA) •HOLD signals are output by open collector circuits. Therefore, user’s remote controller circuit for these pins should be designed as open collector output circuits or Transistor Transistor Logic (TTL) level. •Number 34 pin (+12 V) should be used only for our remote controller AG-A600. © AC Power Cord 3-prong grounded type. Do not defeat its purpose. - 5 - © Video Input Connector (BNC type) Video Input Connector (Loop through type) This connector can bridge the Video Input Connector ©. AG-6850H only © Video Output Connector (BNC type)