Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Turn the MIC VOL 2 control for the microphone connected to MIC IN 2. Setting the MIC VOL 1 and/or 2 control(s) to the centre position provides the best microphone volume. To control the echo effect Turn the ECHO control. This controls both microphones’ echo effect in the same way. To get the best effect, adjust the microphone volume to a slightly higher level than the music volume. Additional Operations SLV-KF295SV/XF245SV 3-858-368-11 (1) Reducing the playback vocals (Karaoke Pon) You can use ordinary music sources with vocals for karaoke with this function. Use hi-fi stereo music sources. Set KARAOKE PON to ON. The singer’s voice will be reduced. KARAOKE PON To cancel Karaoke Pon Set KARAOKE PON to OFF. Searching with the AMS function The AMS (Automatic Music Sensor) function searches for the beginning of the next or previous song by detecting a blank space between songs. Present position Blank space 1 Press p STOP. 2 Press =/+AMS. • To locate the beginning of the next song, press + AMS. • To locate the beginning of the previous song, press =AMS. The unit starts searching and stops automatically when it locates the beginning of the next or previous song. 3 Press a PLAY to start playback. =/+ AMS a PLAY pSTOP continued Additional Operations SLV-KF295SV/XF245SV 3-858-368-11 (1) Karaoke sing along (SLV-KF295SV only) (continued) Tip • When you sing along with music played back on equipment connected to the LINE IN jacks on the unit, play the music source and follow steps 1 and 4 on page 16. Notes • If the sound is reproduced through a stereo amplifier, turn down the volume of amplifier before operation. • If streaks appear during playback, select the colour system that the tape was recorded in (see “To set the colour system” on page 11). • If feedback occurs, turn down the microphone or TV volume, or move the microphone away from the speakers. • Karaoke Pon does not work with the following tapes: – tapes on which different vocal sounds are recorded on the left and right channels, such as a duet; – tapes recorded monaurally; or – tapes on which sound sources are recorded with strong echo effects and chorus effects. • The AMS may not work correctly when: – the tape quality is poor, – a song is very short (less than 40 seconds), – the interval between songs is very short (less than 6 seconds), – a high level sound is recorded between songs or at the beginning of a song, – there are low level passages or passages without sound in a song, – narration is recorded at the beginning of a song, – fade-in or fade-out recording is made on the tape, or – AMS starts from the very beginning of the tape or near an interval between songs. Additional Operations SLV-KF295SV/XF245SV 3-858-368-11 (1) Adjusting the picture Adjusting the tracking Although the unit automatically adjusts the tracking when playing a tape, distortion may occur if the tape was recorded in poor condition. If so, manually adjust the tracking. Press $/4TRACKING $/4 TRACKING NORMAL/SLOW to obtain the NORMAL/ best possible picture. The SLOW distortion should disappear as you press one of the two TRACKING buttons. If you cannot get a AUTO/ clear picture with manual MANUAL adjustment, press TRACKING AUTO/MANUAL to return to automatic adjustment. About OPC OPC (Optimum Picture Control) automatically improves playback quality by adjusting the unit to the condition of the video heads and tape. The OPC function automatically works on all types of tapes, including rental tapes. You can play a tape using the OPC function even if the tape was not recorded with it. Notes • The auto tracking function works automatically when you play back a tape just after inserting it. • Sufficient picture quality may not be obtained when playing back tapes recorded on another VCR or tapes in poor condition. • When a tape recorded with the copyguard system is played back, intermittent distortion may appear in the upper portion of the picture. However, this is not a malfunction of the unit. Additional Operations SLV-KF295SV/XF245SV 3-858-368-11 (1) Editing with another VCR How to connect to record on this unit TV Other VCR (Player) This unit (Recorder) LINE IN LINE OUT VMC-810 audio/video cable (not supplied) : Signal flow Tip • If the other VCR is a monaural type, use a connecting cable like the Sony VMC910MS. Notes • Make sure you connect the plugs to jacks of the same colour. • When connecting the units, do not simultaneously connect the LINE IN and LINE OUT jacks on your unit with the other VCR. A humming noise may occur if you do this. Additional Operations SLV-KS295SV/XF245SV 3-858-368-11 (1) Operation (when recording on this unit) You can make a copy of a tape using this unit for recording or playback. The unit cannot record TV programmes directly since it does not have a TV tuner. Before you start editing • Turn on your TV and set it to the video channel. 1 Insert a source tape with its safety tab removed into the other (playback) VCR. Search for the point to start playback and...
Otros modelos de este manual:VCR / vídeo - SLV-KF295SV (586.06 kb)