Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
There are no user-serviceable parts inside. Refer servicing to qualified service personnel. 2. Do not expose the camera to rain or moisture, and avoid operation in wet areas. Take immediate action if the camera should become wet. Turn the power off and request servicing from qualified service personnel. Moisture can damage the camera and create danger of electric shock. 3. Do not drop anything inside the camera. Dropping metal for example inside the camera could permanently damage the unit. If anything is dropped inside the camera, turn off the power immediately and request service from qualified service personnel. 4. Never aim the camera at bright objects. Whether the camera is in use or not, never aim it at the sun, or other extremely bright objects as this could cause blooming. 5. Do not use the camera beyond its temperature, humidity or power source ratings. This camera is designed for indoor use. (a) The ambient temperature must not range beyond 14°F - 122° F (— 10°C - +50°C). (b) Avoid using the camera when the humidity is above 90'/.. (c) The input power source must be DC 12V, 260 mA. MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS - 3 - 1. HD/VD Termination Switch (SW 1) This switch terminates the HD/VD signals with 75 ohms when this switch is turned to the ON position. 2. Mode Selection Switches (SW 2 9 pin) These switches are used to select the camera operation mode. SW No. Description 1 AGC ON/OFF 2 Gain Up ON/OFF 3 Gamma ON/OFF 4 Accumulation Field/Frame 5 No connection 6 Latch ON/OFF 7 Data-2 B Data-1 9 Data-0 - 4 - Contents of the switches 1. AGC : The AGC does not functions accurately under the Gate Sensor Control modes. 2. Gain Up: Switch ON —► 6 dB up at AGC OFF 3. Gamma : Switch ON —► 0.6 Switch OFF —* 1.0 4. Accumulation Field/Frame : Switch ON —► Field Accumulation Switch OFF —+ Frame Accumulation 5. Latch: Switch ON —» The frame reset signal is latched by internal HD signal. 6. (Data-2), 8 (Data-1), 9 (Data-0): The Electronic Shutter Speed can be set as follows. 3. 7 Switch 8 9 Shutter Speed (seconds) OFF OFF OFF NORMAL OFF OFF ON 1/125 OFF ON OFF 1/250 OFF ON ON 1/500 ON OFF OFF 1/1000. ON OFF ON 1 /2000 ON ON OFF 1/4000 ON ON ON 1/10000 The Shutter Speed does not functions accurately under non-interlaced synchronization. - 5 - Camera Cable Cormector(12-pin) This connector is used for connection of the optional Camera Cable GP-CA34 or GP-CA33. Pin No. Description 1 Ground 2 + 12VIN* 3 Ground tor Video Out 4 Video Out 5 Ground for HD 6 HD In/Out 7 VD In/Out or frame reset in e Ground 9 No connection 10 Ground for sensor gate control 11 Sensor gate control 12 Ground lor VO ©