Votos - 3, Puntuación media: 3.3
(
)
)
|
Resumen del manual
*60 Sec.* 12 Door Lock Pulse Time 3 Sec. *0.75 Sec.* 13 Double Unlock Pulse 2 Pulses *1 Pulse* 14 Lock After Remote Start/Abort OFF *ON* 15 NOT USED N/A N/A 16 Timed Crank or Tach Monitor Pre-Set *Tach Monitor* 17 Blue/Black Wire Function AUX #2 *(-) Run / Ignition* 18 Siren Chirps with Arm/Disarm OFF *ON* 19 “Wake Up" pulse on Unlock (1-sec. +12V to IGN) ON *OFF* 19 OPTION PROGRAMMING TABLE 20 PINK Wire function Carjack *Glow Plug* 21 Starter Cranking Time (Option #16 is set to Timed Crank) 0.75 Sec. *0.5 Sec.* 1.0 Sec. 1.5 Sec. 22 Diesel Glow Plug Delay 10 Seconds *Monitor Glow Plug 20 Seconds 30 Seconds 23 Remote Start Engine Run Time 12 Minutes *24 Minutes* 36 Minutes 48 Minutes 24 Smart Tachless Voltage Adjustment 80-100% -1% 1% *Set to 93% for default* 25 Horn Pulse Pulse When Trigger Pulse When Trigger and Arm/disarm *Pulse When* Trigger, Arm/disarm and warning 26 Aux # 3 Steady Momentary *Momentary* Timed Latch On/Off 27 Aux # 3 Time : 1 to 255 sec. -1 Second +1 Second *Default 12 Sec.* 28 Aux # 4 Steady Momentary *Momentary* Timed Latch On/Off 29 Aux # 4 Time : 1 to 255 sec. -1 Second +1 Second *Default 12 Sec.* 30 Reset Options to default (*) *Reset All Options* PROGRAMMABLE OPTION DESCRIPTIONS: 1. ENGINE MONITORING: This option sets how the unit monitors your engine. You can program either for Tach mode in which the unit uses a Tach signal (RPM) or for “Ultra-Smart” Tachless mode that monitors voltage level. See pages 15-16 for more information and additional steps for actual Tach learning and Tach finder modes. 2. AUTOLOCK/UNLOCK W/IGNITION: Controls whether the doors will automatically lock when the ignition is turned on and unlock when the ignition is turned off. Doors will not lock if they are open to prevent locking the keys in. 3. PASSIVE ARMING Passive Arming With Ignition or Last Door: With this option ON, the unit will arm itself 30 Seconds after the ignition is turned off and/or the last door has been closed. Lights will flash twice when last door is closed indicating passive countdown. If a door is reopened, the system will wait and begin countdown again when closed. The LED will flash rapidly during 30 second count down. 20 PROGRAMMABLE OPTIONS Cont. 4. ACTIVE RE-ARM: Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not been opened. This is handy if the vehicle is accidentally disarmed without your knowledge. 5. PASSIVE LOCKS: This option controls whether the doors will lock when Passive Arming occurs. Note: This may increase the risk of locking keys in the vehicle. 6. PARKING LIGHTS ON WITH DISARM: Keeps parking lights on when system is disarmed to assist in locating and providing illumination near your vehicle when approaching at night for safety. 7. GREEN/RED WIRE PROGRAMMING: TRUNK POP (AUX 1) or M.A.P. OUTPUT: This option controls whether the system’s GREEN/RED wire functions as Remote Aux. Output 1, or functions as an Output for (MAP) Mobile Accessories Protection. Mobile accessory protection activates only in Valet Park Mode. See Wiring Section page 4 for specific details and a diagram. 8. Double Button Press for Remote start and Trunk release: This option will allow you to change whether the Remote starter and Trunk release activate by a single . second press or a double button . second press. 9. SIREN CHIRPS WITH REMOTE START ACTIVATION: This option controls whether the system gives 3 short siren chirps when engaging a remote start. 10. DISARM WITH TRUNK POP (AUX. OUTPUT 1): Controls whether the system will or will not DISARM when the trunk pop or AUX. feature is used. When the feature is turned on the unit will DISARM when opening trunk or using an auxiliary device controlled by the Green/Red wire. 11. 10/60 Sec. OPEN DOOR WARNING: This setting changes the delay time in which the alarm system begins to monitor the Door circuit. This option can prevent the alarm from giving warning chirps on vehicles with a delayed dome light. 21 PROGRAMMABLE OPTIONS Cont. 12. DOOR LOCK/UNLOCK PULSE TIME: This option controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The standard pulse time for most vehicles is 0.75 Sec. The 3 sec. setting may be required for Mid 1980’s through Mid 1990’s European Vehicles that require a long lock and unlock pulse to operate Vacuum door lock systems. 13. DOUBLE UNLOCK PULSE: With this option ON, the unit will send 2 unlock pulses when the system is disarmed. This feature may be required for interfacing a Factory alarm or keyless entry system. 14. LOCK DURING/AFTER REMOTE START: This option controls whether the unit will automatically lock during and after a remote Start abort or time-out. 15. NO OPTION / NOT USED 16. TIMED CRANK or TACH MONITOR MODE: This option controls whether the system uses a tach wire to control the starter or uses a pre-set cranking time. 17. BLUE/BLACK WIRE PROGRAMMING: (NEG.) IGNITION OUTPUT or AUX #2 OUTPUT: This option controls the function of ...