Votos - 3, Puntuación media: 3.7
(
)
)
|
Resumen del manual
NOTE: The Base Station is intended for indoor use only. Carton Inventory Swivel Bushing Sun/Rain Shield Mounting Plate AC Adapter Base Station Passive Infra-Red (PIR) Motion Sensor Rubber Pads Operation & Features Volume Antenna On/Off Button BASE STATION On/Off: To turn the Base Station on and off, hold down the power button until you hear the on/off tone. Volume: The Base Station is equipped with adjustable volume controls. The lowest volume setting is the mute feature. Batteries: If the AC adapter is not connected, the AA batteries in the Base Station should last up to one week. If the Base Station batteries are low, the Base Station will beep every 30 minutes. The AA batteries in the PIR Motion Sensor will last up to 2 years depending on use (lithium batteries are recommended for colder environments). If the PIR Motion Sensor batteries are low, the Base Station will beep every 30 minutes until the batteries are replaced. The PIR Motion Sensor will continue to operate with a low battery, however the light will not illuminate. For peak performance, inspect batteries annually and replace as needed. Programming Additional PIR Motion Sensors: The Base Station can learn the code of up to 7 additional PIR Motion Sensors, responding with unique buzzes. To program additional PIR Motion Sensors see Step 4. To order additional PIR Motion Sensors call 1-800-528-9131. Clear Memory: Press and hold the Learn Button on the Base Station until 3 beeps are heard. 1 2 Antenna ON OFF 1 2 SWITCH SETTINGS Switch #1 Switch #2 Learn Button OFF Low Sensitivity ON High Sensitivity (Default) OFF 15 Feet (4.5 m) Detection Range ON 30 Feet (9.1 m) Detection Range (Default) NOTE: To avoid unwanted detection of small animals move Switch #2 to OFF. Assembly & Programming Attach PIR Motion Sensor box to mounting plate with large silver screw. Tighten screw until PIR Motion Sensor stays in place when repositioned. Install 4 AA Alkaline batteries. (Lithium batteries recommended for colder environments.) LED light will fl ash. Plug in the Base Station. Adhere rubber pads to the bottom of the base. 4 AA batteries are optional in case of a power failure. OPTIONAL AC Adapter Input A Ensure Base Station and PIR Motion Sensor are in close proximity to each other. Press and release Learn Button on Base Station. Buzzer will sound. B Within 60 seconds, press the Learn Button on the inside of the PIR Motion Sensor. LED light will illuminate and Base Station will buzz. Learn Button 1 2 PIR Motion Sensor SWITCH #1: SWITCH #2: 3 4 Learn Button Insert battery pack facing away from circuit board and fasten cover with the smallest screws (provided). NOTE: Ensure the batteries do not touch the circuit board and the antenna and battery wires are not pinched. 5 6 PIR MOTION SENSOR INSTALLATION Mount PIR Motion Sensor horizontally on solid surface 3-5 feet (1-1.5 m) off the ground and within 1/2 mile (0.8 km) of Base Station (rotate sensor to access screw holes). Unit should be able to swivel as needed. Attach sun/rain shield. NOTE: Keep PIR Motion Sensor antenna away from metal objects. Do not mount PIR Motion Sensor in direct sunlight, near moving tree branches, or in the path of a sprinkler system. 4 feet (1.2 m) 10-20 feet (3-6 m) Vehic...
Otros modelos de este manual:Vídeo - CWA2000 (314.27 kb)