831.297241 Serial No. The serial number can be found in the location shown below. Write the sedal number in the space above. Serial Number _kCAUTION!: Read all safety precautions and instructions in this manual before using this equipment. Keep this manual in a safe place for future reference. OWNER'S MANUAL SEARS, ROEBUCK AND CO., HOFFMAN ESTATES, IL 60179 FULL 90 DAY WARRANTY For 90 days from the date of purchase, when proper assembly and maintenance procedures detailed in the Owner's Manual a

Exercise additional caution when skiing at competitive speeds. Beginners should be towed at slower speeds that allow for reasonable control and stability. • Water skiing instruction is recommended before use. Instruction will teach general safety guidelines and proper skiing techniques, which may reduce your risk of injury. BINDING MOUNTING INSTRUCTIONS NOTE: It is not recommended that any extra holes are drilled into the top surface of the skis. O’Brien slalom skis have phenolic strips under th

FIN ADJUSTMENTS HORIZONTAL ADJUSTMENTS Moving the fin back towards the tail of the ski increases the pressure in the forebody of the ski during the pre-turn and turn, resulting in more tip area of the ski engaging the water. This action will cause increased drag and deceleration in the pre-turn as well as larger arcing turns. Moving the fin forward causes the tip of the ski to ride higher with more of the forebody out of the water during the turn. As a result, the ski will accelerate slower and

O’Brien uses the very best materials to help insure a long-lasting, quality product. Please complete and remove the warranty card included with your new ski, and mail it within 10 days of purchase. Before using your new product, please take a minute to read the following warning and safety information. Also enclosed are instructions on how to fine tune your new ski and bindings. These instructions will help you obtain the most enjoyment possible from your new O’Brien product. WARNING ! Use of th

Be sure to hold the console mast firmly as it will not stay in the upright position on its own. E Insert DOLT (D) and 1 FLAT WASHER (E) through LEFT CONSOLE MAST followed by a WAVY WASHER (F) and attach to MAIN FRAME. A Pull LEAD WIRE through RIGHT CONSOLE MAST After pulling the LEAD WIRE through the mast, the top of the CONSOLE CABLES should be located at the top of the mast Detach and discard LEAD WIRE. B Open HARDWARE BAG 2. C Move RIGHT LINKAGE ARM into position and attach to ELEVATION F

Please call toll free 1-800-6OBRIEN for customer service department. Warranty Dept. cannot issue RA’s. 4. Customer return shipments must (1) have a pre-approved RA number on file in distribution center prior to receipt of shipment (2) have one carton containing a pack slip, and (3) must have the RA number clearly identified on the outside of the carton containing the pack slip or the complete shipment will be refused at the receiving door and returned to the consumer at consumer expense. 5. Warr

Binding Model _ Purchase Dale PRODUCT INSTRUCTIONS AND WARNINGS Watersports can be safe and fun for all levels of enthusiasts. The Operator's Manual is presented to enhance your enjoyment of the sport. It is intended to alert you to some of the potentially dangerous conditions that can arise in all watersports. To reduce your risk of injury or death, follow these guidelines: * • Use correct size wakeskate. • Inspect wakeskate and fins for loose screws, wear, cracks, or delamination. • Chec

Too slow is better than too fast. All riders should be towed at boat speeds that allow for reasonable control and stability. • During use, the wakeskate may hit the rider and cause injury. Use of a helmet and/or shoes specifically designed for wakeskating may reduce the risk of injury. • Attempting land or dock starts can increase the risk of injury or death. USE ONLY ON WATER. • Do not use in shallow water or near shore, docks, pilings, swimmers or other watercraft. • Always wear a U.S. Coa

It is very important that all screws are checked for snugness each time before use of the ski, but without overtightening. Never use a ski that has missing or loose screws. O’BRIEN BINDINGS BIO BINDINGS: The BIO bindings feature a front lace system that allows them to open up for ease of entry and exit. They also feature built in lateral stiffeners, contoured EVA footbeds, and fabric overlays to fine tune the level of comfort and support preferred. TARGA BINDINGS: The Targa bindings feature a fr

Use only a soft cotton cloth. NOTES FROM PLACE STAMP HERE PO BOX 97087 REDMOND, WA 98073 O’BRIEN CUSTOMER RETURN/WARRANTY POLICY 1. All customer returns (warranty and non-warranty) require an approved return authorization issued by customer service or the shipment will be refused and sent back to the con sumer at the consumer’s expense. 2. O’Brien Warranty: All O’Brien Product is warranted to the original retail purchaser to be free of defects in material and workmanship except as provided in 2A