Iniciar sesión:
Votos - 3, Puntuación media: 3.7 ( )

Manual de usuario Haier, modelo QBJ1-150A58E

Fabricar: Haier
Tamaño del archivo: 524.12 kb
Nombre del archivo:
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


If the water pressure isn't enough for water supply, please install an pressurize equipment. 5. When the hot water is to be used, don't place the spray head face yourself until the water temperature is suitable. 6. This product can supply the water depend on the fall of the tank and the water exit , an pressurize equipment is recommended while the water couldn't be supplied normally due to the low fall. 7. Do not supply cold water more than once in a low solar irradiance day. 8. The energy is from solar, in the days that lack of solar such as rainy or snowy day, the temperature of the water may can't reach your demand, If there isn't electric heating , it may not be used normally. 9. Make sure the evacuated tubes clean, hose off the dust and dirt on the tubes and the reflector before the winter comes. 10. The evacuated tubes resist as low temperature as -70 when tubes is emptied. The tank should remain filled up during continuously cloudy or snowing days in winter, in addition every two days the cold water in the tank should be changed to prevent the water in the tank from freezing which might damage the tubes. 2 Before use Before use Notice Please take time to read this manual and familiarize yourself with the function of this production. 1. Please check out the packing list. 2.If you fix electric auxiliary heating and controller, please select Haier equipped products. 3. To avoid the scald, please mix the hot and the cold water before use it. 4. In order to protect the tank ,please don't refit or wall up the air supply pipe and the overflow pipe. 3 Assembly Instruction Assembly Instruction The location: 1. Please install the solar water heater in the area that avoid the thunder. 2. Solar water heater angle range: east to south for 10 , west to south for 15 . 3. There shouldn't be any hindrance in front of the heater ,or the distance should over L, L=H/tg(66.5 a) H:height of the hindrance; a: latitude of the area Notice: The solar water heater shall be installed by professional. Exterior and installation dimension: Models Exterior dimension(mm) Installation dimension(mm) QBJ1-130A58E QBJ1-150A58E QBJ1-175A58E QBJ1-200A58E QBJ1-230A58E QBJ1-270A58E Remarks: The permitted error limit of above parameters is 10%. 4 A D B H Assembly Instruction Assembly Instruction Tank assembly 1. Unpacking the tank, rip off the protection film. Uninstall the nut and cushion. 2. Place tank onto tank bracket cradle, inserting protruding bolts into holes. fasten with nuts. Notice: 1. Rip off the protection film after the installation to avoid the destroy of the tank, and please don't use the sharp tool. 2. Leave nuts loose since some adjustment may be necessary after fitting tubes. 3. When assembling the water tank, keep the center line of vacuum tubes connecting holes parallel with the diagonal pillar of bracket. Frame assembly Please consult the accessional paper for figure of the frame and packing list in the packing of frame. Frame fastness 1. Peg the feet of the ...

Otros modelos de este manual:
Calentadores de Agua - QBJ1-130A58E (524.12 kb)
Calentadores de Agua - QBJ1-175A58E (524.12 kb)
Calentadores de Agua - QBJ1-200A58E (524.12 kb)
Calentadores de Agua - QBJ1-230A58E (524.12 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría