Votos - 0, Puntuación media: 0 ( )

Fabricar: Bosch Tamaño del archivo: 2.07 mb Nombre del archivo: Idioma del manual:

The appliance must only be installed in a frost-free area. If the tank has not been used for more than three months, it must be thoroughly flushed out until there are no more bubbles. Operation The water temperature can be adjusted from * to 85.C using the rotary knob. We recommend a setting of 60.C. Heat loss and build-up of scale are kept to a minimum at this setting. Anti-corrosion anode: ”anode” lights up during normal operation ”service” flashes: the anti-corrosion anode has been shut down and, with the dual-circuit design, the heater has been switched off. Contact the after-sales service. The heater can be temporarily activated by pressing (maximum water temperature 40.C). If the tank is not to be used for a long time, set the rotary knob to *, but do not disconnect from the mains current (because of the anti-corrosion anode). Select the required temperature; the heater will warm up the water during off-peak hours. All 6 indicator lights light up once the required temperature has been reached. The number of lights lit decreases as the amount of hot water available decreases. Press to activate the fast-heating funcion at any time. This function will switch off automatically once the temperature set has been reached. The indicator light goes out. Cleaning Wipe the outside using a gentle cleaning fluid. Do not use a scourer. Maintenance; Descaling, After-sales service To prevent damage, repairs must only be carried out by an after-sales representative approved by us. The first maintenace service by our after-sales service should be performed approximately two years after the date the appliance was first used. The appliance can be descaled if necessary at this stage. After-sales will recommend a date for the next maintenance service. Please quote your E no. and FD no. when you contact after-sales. MODELL DG80025 DG10025 DG12025 DG15025 Capacity Litres 80 100 120 150 Weight, full kg 106 133 162 197 Rated overpressure bar 6 Cold and warm water connection G1/2A Heating time to approx. 85 °C,with cold water inlet temperatur 15 °C 1 kW hours 6,8 8,5 10,3 12,8 2 kW 3,4 4,3 5,1 6,4 3 kW 2,3 2,8 3,4 4,3 4 kW 1,7 2,1 2,6 3,2 6 kW 1,1 1,4 1,7 2,1 Assembly Safety advice The tank must only be connected and commissionedby an expert. IEC 60364-7-701 (DIN VDE 0100 Part 701) should be observed if the appliance or any electrical accessories are to be installed in a bathroom. Comply with legal requirements and the connection requirements of the electricity supply company and the water company. The appliance must be connected permanently to securely laid cables and to the earth conductor (yellow/green). An all-pole isolator with a contact gap of at least 3 mm must be fitted on the installation side. Before installation, disconnect the electric cable from the current and block off the water pipe. First connect the water and then the electricity. It must no longer be possible to touch the live parts after installation. Preparation for installation The appliance mus...

Descargar ahora

Introduzca dos números de la imagen: