Refer to Figure 56. Receiver Shutdown of Burner • In the remote, auto mode the valve shuts off if it does not receive a signal within 3 hours from the transmitter • In the local mode the valve does not shut off • In the remote, manual mode the vavle shuts off if it does not receive a signal within 6 hours from the transmitter Thermopiles • The negative leads (white) must be connected to the terminals with the one white dot marked next to them • Each thermopile must provide at least 500 mV open c

• Check the ground lead from GND (BURNER) terminal on the module to the pilot burner. Make sure connections are clean and tight. If the wire is damaged or deteriorated, replace it with No. 14-18 gauge, moisture-resistant, thermoplastic insulated wire with 105 C (221 F) minimum rating. • If flame rod or bracket are bent out of position, restore to correct position. • Replace pilot burner/igniter sensor if insulator is cracked. Step 3: Checksparkignitioncircuit. Youwillneeda shortjumper wire made

When the internal beads of each starting outer pipe line up, rotate pipe section clockwise 90° (approximately 3 inches). The vent pipe is now locked together. Continue replacing components per the vent system configuration. Be certain that each succeeding vent component is securely fitted and locked into the preceding component in the vent system. Reassembly and Resealing Gas Accumulation Relief System Glass Frame Assembly and Combustion Chamber Whenever the glass frame assembly is pivoted open

Wall Switch, FWS-1 Connect the green and red, stripped and bare, wires on the REMOTE/OFF/ON switch wire harness to the wall switch. Turn the REMOTE/OFF/ON switch to the REMOTE position. Pivot the rocker switch on the FWS-1 to the ON position. Wall Thermostats (optional) TRW - Wireless for Millivolt models TMV - Reed switch for Millivolt models Battery Operated Remote Controls, FRBC, FBRTC, and TRW Connect the green and red, stripped and bare, wires on the REMOTE/OFF/ON switch wire harness to the

43 Maintenance and Service............................................................................................................. 44 Parts View...................................................................................................................................... 45 Parts List ....................................................................................................................................... 46 FBB4 Optional Variable Speed Blower Installation ..............

. If you cannot reach your gas supplier, call the fire department. - Installation and service must be performed by a qualified installer, service agency, or the gas supplier. GAS-FIRED DIRECT VENT GAS FIREPLACE HEATER MODEL SERIES DVP42FP3(0,1,2,3)(N,P)-1 (MILLIVOLT STANDING PILOT) DVP48FP3(0,1,2,3)(N,P)-1 (MILLIVOLT STANDING PILOT) DVP42FP7(0,1,2,3)(N,P)-1 (INTERMITTENT PILOT) DVP48FP7(0,1,2,3)(N,P)-1 (INTERMITTENT PILOT) DVP42FP9(0,1,2,3)(N,P)-1 (REMOTE RF MODELS) DVP48FP9(0,1,2,3)(N,P)-1 (REM

• Un calentador de habitaciones sin ventalacion externa que tenga una capacidad mayor de 10,000 Btu por hora no debe instalarse en una alcoba o en un bano. • Debido a temperaturas altas, el aparato debera ubicarse fuera de zonas transitables y lejos de muebles y cortinas. • Ninos y adultos deberan ser informados del peligro de la alta temperatura de la superficie y deberan permanecer lejos para evitar ignicion de ropa o quemaduras. • Ninos menores de edad deberan ser cuidadosamente supervisados

10. Aflojar la tuerca que sostiene el control manual de gas del soporte. Remover el control manual de gas del soporte. 11. Como las partes son reemplazadas en orden contrario, revisar si existen fugas de gas en todas las conexiones antes de reemplazar la persiana inferior y el reflector al gabinete. Para Remover el Quemador Principal del Gabinete 1. Desconectar el abastecimiento de gas al calentador. 2. Apagar el abastecimiento electrico al calentador, si el ventilador opcional se ha instalado e

Estado de Massachusetts: La instalacion se debe hacerse por un fontanero licenciado del Commonwealth de Massachusetts. Los vendedores de calefatores sin ventilacion suplementales de gas naturale o propano proporcionaran a cada comprador una copia de 527 CMR 30 durante la venta de la unidad. En el estado de Massachusetts, calefatores sin ventilacion de espacio de gas propano y natural son prohibidos en habitaciones y banos. Esta instalacion debe concordar con codigos locales. En ausencia de codig

Lado derecho 8 pulgadas (203mm). No instalarlo en un closet o armario. Pared trasera 0 pulgadas (0mm). Techo 36 pulgadas (914mm). Espacio libre vertical minimo de una proyeccion arriba del aparato (repisa, antepecho de ventana, etc.) 36 pulgadas (914mm). Piso sobre superficie de alfombras, mosaicos, etc. 2 pulgadas (51mm). Proveer espacios libres adecuados alrededor de aperturas de aire. Proveer espacios libres adecuados y accesibles para dar servicio y operacion apropiada. Figura 8 (SR-30) INST