Votos - 3, Puntuación media: 4 ( )

Fabricar: Petsafe Tamaño del archivo: 221.54 kb Nombre del archivo: Idioma del manual:

Once the parts are clean, reassemble the pump by replacing the impeller, stator, flow control (See Fig. 4) and the intake plate. Thread pump power cord back through pump cord pass-through and suction cup loop, and position pump onto the pump connector post in the upper shell (See Fig. 1a & 1b). Grasp the rubber fitting and pull through hole in upper shell until it snaps into place sealing the opening (See Fig. 1a & 1b). The length of the pump power cord may need to be adjusted by pulling either end to position pump onto pump connector post. The filter should be replaced every 2 -4 weeks to maintain filtered, fresh and clean water. Small food particles and hair must be cleaned between the intake and filter as needed to maintain strong current flow. IMPORTANT: Warranty may be voided if pump is not cleaned regularly. Product Specifications: Voltage/Power Consumption 120VAC 60Hz 3.3 WATTS 12 Volts low-level power adapter output Accessories: To purchase replacement parts or accessories, contact PetSafe® Customer Care Center at 1-800-732-2677 or by visiting Replaceable Filters, 3-pack PFD17-12905 Fig. 2 Pump Impeller Stator Flow Control Intake Plate With your thumb and forefinger, gently squeeze the sides of intake plate, and pull off. Remove the flow control, stator and impeller. To remove impeller use a fingernail to lift out; it is held in magnetically. Replaceflowcontrolbyplacing post into opening onthepumpmotor.AlignflowcontrolknobtoopeningonintakeplateandattachintakeplateFig. 4Fig. 3 Clean with warm soapy water. Use a cotton swab or a small cleaning brush to get into the motor cavity and remove any build-up. to pump. Terms of Use and Limitations of Liability 1. Terms and Use -This product is offered to you conditioned upon your acceptance without modifications of the terms, conditions and notices contained herein. Use of this product implies acceptance of all such terms, conditions and notices. 2. Proper Use -Includes reviewing the safety precautions listed. 3. No Unlawful or Prohibited Use -This product is designed for pets only. This device is not intended to harm, injure or provoke your pet. Using this product in a way that is not intended could result in violation of Federal, State or local law. 4. Limitations of Liability -In no event shall Radio Systems® Corporation be liable for any direct, indirect, punitive, incidental, special or consequential damages whatsoever arising out of or connected with the use or misuse of this product. Buyer assumes all risks and liabilities from the use of this product. 5. Modifications of Terms and Conditions -Radio Systems® Corporation reserves the right to change the terms, conditions and notices under which this product is offered. Radio Systems® Corporation · 10427 Electric Avenue · Knoxville, TN 37932 · 1-800-732-2677 · · 400-1281-17/2 ...

Descargar ahora

Introduzca dos números de la imagen: