Votos - 2, Puntuación media: 5 ( )

Fabricar: Holmes Tamaño del archivo: 131.96 kb Nombre del archivo: Idioma del manual:

When the filter life indicator light is red, it is time to change the filters. PRE-OPERATING INSTRUCTIONS NOTE: The door should not be opened when the unit ison its side. 1) After removing the unit from the box, take the plastic covering off the unit. 2) Place unit with air intake grill pointing up. 3) Open the door of the air purifier. 4) The Carbon filters, which are packed in a plastic bag in the box, should be put on each of the HEPA filters. The plastic tabs on the HEPA filter will hold the carbon in place (fig. 1). 5) Close the air purifier door by pushing firmly against the right hand side of the door. OPERATING INSTRUCTIONS 1) Select location where air intake grill and filtered air outlet are not obstructed. 2) Plug into a 120V AC electrical outlet. 3) The air purifier is now ready for your use. Please set the unit to the desired speed setting; High (IIII), Medium (III), Low (II), or Sleep (I). CLEANING AND MAINTENANCE INSTRUCTIONS 1) Turn the air purifier off and unplug it before cleaning. 2) The outside of the air purifier can be cleaned with a soft, clean dampened cloth. 3) The filtered air outlet on the top of the unit can be cleaned of dust with a small, soft brush. 4) If you wish to clean the inside of the air purifier, please only use a dry, soft cloth to wipe it down. Figure 1 A B Figure 2 C A. HEPA FILTER B. CARBON FILTER C. HANG TABS D. AIR INTAKE GRILL E. FILTERED AIR OUTLET F. SPEED CONTROL KNOBS G. FILTER LIFE INDICATOR H. RESET BUTTON I. POWER CORD (not shown) Figure 3 F G H I D E FILTER REPLACEMENT INSTRUCTIONS: 1) On average, HEPA filters need to be replaced every 12-18 months. Carbon filters need to be replaced every 3-6 months. Filter life will vary depending on air quality and usage. 2) Turn off and unplug the air purifier before attempting to replace the filters. 3) Remove each of the filters from the unit by pulling gently towards you. 4) To replace the carbon filter, simply remove the old carbon filter and insert a new carbon in its place, using the plastic tabs as a guideline (see Figure 1). 5) To replace the HEPA filter, discard the old HEPA filters. Put the carbon filter back on the HEPA filter. Insert the new HAPF600 HEPA filter into the unit, by sliding it onto the hang tabs. 6) After replacing the HEPA filters, RESET the Filter Life Indicator by inserting a small object (such as a pin or paper clip) into the hole marked RESET. Replacement filters are as follows: HAPF600 HEPA Filter HAPF600D HEPA Filter (2 pack) HAPF60 Carbon Filter These filters can be purchased at a retailer near you or by calling 1-800-5-HOLMES. NOTE: Carbon and HEPA Filters are not washable and should be replaced at the recommended intervals. TROUBLESHOOTING PROBLEM SOLUTION Unit will not operate • Check to make sure the unit is plugged in. • Check to make sure the unit is on by turning the knob. • If the door is ajar the unit will not operate. Make sure the filters are properly installed and firmly close the door. Decreased air flow • If th...

Descargar ahora

Introduzca dos números de la imagen: