Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
– With the aid of the drilling template, mark the positions of the screws on the wall (Fig. 19). – Pay attention to the minimum clearance of 600 mm for electric cookers and 650 mm for gas cookers. The bottom edge of the template corresponds to the bottom from edge of the hood. – Using the drilling template, drill the 6 holes for the hood (area I of the drilling template) and the two holes for suspending the chimney (area II of the drilling template). In the top two securing holes for the hood, fix the two hooks d with the countersunk screws c. Make sure that the hooks lie flatly on the wall. In certain circumstances you may have to countersink the drill holes. Fit the included dowels a in the other drill holes. Note: pay attention to any special accessories that you may have to fit. – Screw on the retaining bracket for the chimney paneling. – Detach the grease filters. – Hang the hood on the two hooks. Adjust the suspended element with the recessed head screw and align the hood using a spirit level (Fig. 20). 405 103 270 300 15 310 mind. 600 Elektro mind. 650 Gas 230 76,5 160 Fig. 19 Fig. 20 Important: before marking the securing holes, make sure that no electricity or water lines or other lines are laid at the drilling points in the wall. min. 600 electric min. 650 gas – Secure the hood on the wall with the four screws b (Fig. 21 and 22). For exhaust air mode proceed as follows: – Establish the pipe connection. – Establish the electrical connection. – Stainless steel chimney only (AD 010-012/022): pull the protective film off the chimney’s trims. Note: avoid damaging the sensitive metal surfaces. – Fit the top chimney duct unit into the base. Make sure that the fastening holes on the side are at the top. – Put both chimney duct units onto the hood. – Pull the top chimney duct unit up into its final position and secure it with 2 screws on the ceiling holder (Fig. 23). Note: avoid scratches when pulling the elements apart by placing the assembly template, for example, over the edge of the bottom chimney paneling to protect it. – Insert the grease filters. 16 Fig. 21 Fig. 22 Fig. 23 For circulating air mode use the installation set included with the ventilation ducts AD 010-112/122 und AD 011-112/122. You also need an activated charcoal filter (KF 001-010). Proceed as follows: – Slightly loosen the screws of the retaining bracket for the chimney paneling. Hang the angle pieces onto the screws and tighten the screws. – Screw the circulating air switch module to the angle pieces (4 screws). – Shorten the flexible air pipe accordingly. Fix the flexible air pipe with hose clamps (Fig. 24). – Establish the electrical connection. – Stainless steel chimney only (AD 010-112/122): pull the protective film off the chimney’s trims. Note: avoid damaging the sensitive metal surfaces. – Fit the top chimney duct unit into the base. Make sure that the fastening holes on the side are at the top. – Put both chimney duct units onto the hood. – Pull the top chimney du...
Otros modelos de este manual:Aire - AW211190/02 (1.14 mb)
Aire - AW211170/01 (1.14 mb)
Aire - AW210190CH/02 (1.14 mb)
Aire - AW210190/02 (1.14 mb)