Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
The wall plugs must have a secure grip. ¦ The enclosed screws and wall plugs are suitable for solid brickwork. Suitable fasteners must be used for other structures (e.g. plasterboard, porous concrete, poroton bricks). ¦ The max. weight of the extractor hood is 50 kg. Electrical connection : Risk of electric shock! Components inside the appliance may have sharp edges. These may damage the connecting cable. Do not kink or pinch the connecting cable during installation. The required connection data can be found on the rating plate inside the appliance; to do this, remove the metal mesh grease filter. Length of the cable: approx. 1.30 m This appliance complies with the EC interference suppression regulations. : Risk of electric shock! It must always be possible to disconnect the appliance from the electricity supply. The appliance must only be connected to a protective contact socket which has been correctly installed. If the plug is no longer accessible following installation of the appliance, or a fixed connection is required, an all-pole isolating switch must be present on the installation side with a contact gap of at least 3 mm. The fixed connection must only be installed by an electrician. Installation Fitting the upper support frame 1. Before fitting, determine the total height of the support frame and mark the screw holes. Note: The height of the support frame can be adjusted in 20 mm intervals. 2. On the ceiling, mark the centre point of the appliance. 3. Using the enclosed template, mark the positions for the screws on the ceiling. Fitting the lower support frame Fasten the upper and lower part of the support frame at the specified total height using 10 screws. Notes ¦ Ensure that the lower support frame is in the correct position. The open side must be facing the hob control elements. ¦ The support frame can be subsequently re-positioned by loosening the securing screws. ............ 4. Drill four 8 mm diameter holes to a depth of 80 mm for the fasteners and press in the wall plugs flush with the ceiling. 5. Fasten the upper part of the support frame to the ceiling with 4 screws. Note: Ensure that the support frame is in the correct position. The middle bracket defines the preferred side and must be facing the hob control elements. .................................................................................................. 25 Fitting the appliance 1. Hook the appliance from below into the support frame. Note: Ensure that the mains cable is not trapped. 2. Fasten the appliance to the support frame using 2 securing screws. 3. Hook in the retaining clip and screw tight. Connecting the pipes Note: If using an aluminium pipe, smooth the connection area beforehand. Exhaust-air pipe O 150 mm (recommended size) Attach the exhaust-air pipe directly to the air-pipe connector and seal. Exhaust-air pipe O 120 mm 1. Attach the reducing connector directly to the air-pipe connector. 2. Attach the exhaust air pipe to the reducing connector. 3. Seal both joints appropriately. Attaching the flue duct : Risk of injury! From sharp edges during installation. Always wear protective gloves while installing the appliance. 1. Separate the flue ducts. To do this, remove the adhesive tape. 2. Remove the protective foil from both sides. 3. Place both parts of the upper flue on the appliance and push together. Note: The slots of the upper flue must point downwards. 4. Push up the upper flue part and secure with 2 screws. 5. Insert both lower parts of the flue and push together. .. .. .. .... .... . Table des matieres NOTICE D'UTILISATION .......................................................... 26 Precautions de securite importantes ............................... 26 Protection de l'environnement .......................................... 28 Modes .................................................................................. 28 Utilisation ............................................................................ 29 Nettoyage et entretien........................................................ 29 Anomalies – que faire ? ..................................................... 31 Service apres-vente ........................................................... 32 NOTICE DE MONTAGE ............................................................ 33 Precautions de securite importantes ............................... 33 Consignes generales ......................................................... 35 Installation .......................................................................... 36 NOTICE D'UTILISATION Vous trouverez des informations supplementaires concernant les produits, accessoires, pieces de rechange et services sur Internet sous : et la boutique en ligne : : Precautions de securite importantes Lire attentivement ce manuel. Ce n'est qu'alors que vous pourrez utiliser votre appareil correctement et en toute securite. Conserver la notice d'utilisation et de montage pour un usa...
Otros modelos de este manual:Campanas - CD959352/01 (1.96 mb)