Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
The appliance is noisy The appliance is not supported Check if the appliance stands staproperly ble (all the four feet should be on the floor) The appliance does not The appliance is switched off. Switch on the appliance. operate. The lamp does not operate. The mains plug is not connected Connect the mains plug to the to the mains socket correctly. mains socket correctly. The appliance has no power. Connect a different electrical ap- There is no voltage in the mains pliance to the mains socket. socket. Contact a qualified electrician. The lamp does not work. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The compressor operates The temperature is not set cor-Set a higher temperature. continually. rectly. The door is not closed correctly. Refer to "Closing the door". The door has been opened too Do not keep the door open longer frequently. than necessary. The product temperature is too Let the product temperature de- high. crease to room temperature before storage. The room temperature is too Decrease the room temperature. high. The compressor does not This is normal, no error has oc-The compressor starts after a peri start immediately after curred. od of time. pressing the COOLMATIC switch, or after changing the temperature. Water flows on the rear During the automatic defrosting This is correct. plate of the refrigerator. process, frost defrosts on the rear plate. Water flows into the re-The water outlet is clogged. Clean the water outlet. frigerator. Problem Possible cause Solution 14 14 What to do if… Problem Possible cause Solution Products prevent that water Make sure that products do not flows into the water collector. touch the rear plate. The temperature in the The temperature regulator is not Set a higher/lower temperature. appliance is too low/high. set correctly. The temperature in the refrigerator is too high. The door is not closed correctly. The product temperature is too high. Many products are stored at the same time. There is no cold air circulation in the appliance. Refer to "Closing the door". Let the product temperature decrease to room temperature before storage. Store less products at the same time. Make sure that there is cold air circulation in the appliance. Upper or lower square is An error has occurred in meas-Call your service representative shown in the temperature uring the temperature. (the cooling system will continue Display. to keep food products cold, but temperature adjustment will not be possible). dEMo appears on the The appliance is in demonstra- Keep pressed approximately 10 Display. tion mode (dEMo). sec. the OK button since a long sound of buzzer is heard and the Display shut off for a short while: appliance start works regularly. Replacing the lamp The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device. Contact your Service Center Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. Technical data 15 TECHNICAL DATA Dimension of the recess Height 1225 mm Width 560 mm Depth 550 mm Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Positioning WARNING! If you are discarding an old appliance that has a lock or catch on the door, you must ensure that it is made unusable to prevent young children being trapped inside. The appliance shall have the plug accessible after installation. Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. 16 16 Installation The wires in the mains lead are coloured in accordance with the following code: 1 3 5 Green and Yellow: Earth Brown: Live Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present ...
Otros modelos de este manual:Refrigeradores - SKS71200F0 (438.2 kb)
Refrigeradores - SKS71200F0 (438.2 kb)
Refrigeradores - SKS71200F0 (438.2 kb)
Refrigeradores - SKS71200F0 (438.2 kb)