Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
Defrost the freezer compartment once or twice a year or when the formation of ice on the racks is excessive. It is perfectly normal for ice to form on the racks. The amount and speed at which the ice forms depends on room air temperature and humidity and the frequency with which the door is opened. Ice formation is concentrated on the racks at the top of the freezer compartment. If possible, defrost the freezer compartment when it is nearly empty. • Remove the food from the freezer compartment, wrap in a newspaper and group together in a cool place or in a portable cooler. • Leave the freezer door open so that the ice can thaw. • Pull out the defrost water drain and place a tray below it. • Clean the interior of the freezer compartment with a sponge and warm water and/or neutral detergent. Do not use abrasive products. • Rinse the interior and dry thoroughly. • Fit the drain back into place. • Put the food back into the freezer compartment. • Close the compartment door. • Plug in the appliance / reconnect the electricity supply. • Switch the appliance on. HOW TO CLEAN THE REFRIGERATOR COMPARTMENT The refrigerator compartment must be cleaned periodically. Defrosting of the refrigerator compartment is completely automatic. Droplets of water on the rear wall of the refrigerator compartment indicate that the periodic automatic defrost cycle is in progress. The defrost water is routed to a drain outlet and into a container on the compressor from which it evaporates. Clean the defrost water drain outlet regularly using the tool supplied with the appliance. This precaution ensures that defrost water is removed correctly from the interior of the refrigerator compartment. Before cleaning the refrigerator compartment, unplug the appliance from the mains. • Use a sponge with warm water and/or neutral detergent. • Rinse the interior and dry with a soft cloth. Do not use abrasive products CARE AND MAINTENANCE Prolonged disuse 1. Empty the refrigerator and freezer compartments. 2. Unplug the appliance from the mains. 3. Defrost and clean the interior of both compartments. 4. Leave the doors open to prevent the formation of mould, odours and oxidation. TROUBLESHOOTING GUIDE 1. The appliance is not working. • Is there a power failure? • Is the plug properly inserted in the socket? • Is the mains power switch set to ON? • Has the fuse blown? • Is the power cord in perfect condition? • Is the thermostat knob on position • (Stop)? 2. Temperature is not low enough. •Are the doors closed properly? • Is the appliance installed next to a heat source? • Is the thermostat setting correct? •Are the air circulation grilles blocked? 3. Temperature is too low. • Is the thermostat setting correct? 4. Water collects at bottom of refrigerator compartment. • Is the defrost water drain outlet blocked? 5. The interior light is not working. Perform the checks for problem 1, and then: •Unplug the appliance. To access the bulb, refer to the instructions and illustration on the attached product description sheet. • Check the bulb and, if necessary, replace it with an equivalent one (15 W max.). 6. Red LED on freezer control panel remains lit / acoustic alarm sounds. (see How to use the freezer compartment) • Have you just loaded a large quantity of fresh food? • Freezer door properly closed? Notes: • The front edge of the appliance may be hot. This prevents the formation of condensation and is not a defect. • Gurgling and hissing noises due to expansion in the refrigerant circuit are normal. AFTER-SALES SERVICE Before calling After-sales Service: 1. See if you can solve the problem yourself with the help of the T roubleshooting Guide. 2. Switch the appliance on again to see if the problem persists. If it does, switch off and wait for about an hour before switching on. 3. If the problem persists after this action, contact After-sales Service. 0000 000 00000 Note: The direction of door opening can be changed. If this operation is performed by After-sales Service it is not covered by the warranty. SERVICE Specify: • the nature of the fault, • the model, • the service number (the number after the word SERVICE on the rating plate on the inside of the appliance), • your full address, • your telephone number and area code. INSTALLATION • Install the appliance away from heat sources. Installation in a hot environment, direct exposure to the sun or installation near heat sources (heaters, radiators, cookers) will increase power consumption and should therefore be avoided. • If this is not possible, the following minimum distances must be respected: • 30 cm from coal or paraffin stoves; • 3 cm from electric or gas cookers. • Install the appliance in a dry, well-ventilated place. • Clean the interior (see the relative heading in this handbook). • Fit the accessories. Electrical connection • Electrical connections must be made in accordance with local regulations. • Voltage and p...