Iniciar sesión:
Votos - 3, Puntuación media: 4.3 ( )

Manual de usuario CDA, modelo FF150

Fabricar: CDA
Tamaño del archivo: 163.51 kb
Nombre del archivo: 5e0f051d-f448-407d-9749-bc487fd27322.pdf
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Resumen del manual


The fridge may have an odour to it at first use. This will disappear as the appliance cools. Please note: • The appliance will work continuously until it comes down to the correct temperature. • If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary damage to the compressor. This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places. • The plug should be fully accessible at all times. • To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance. • The cooling system at the rear of the appliance must not touch the rear wall. • The appliance must be installed with adequate ventilation. Ensure that there is 15 cm clearance above the appliance, and that there is space between the rear of the appliance and the wall. Reversing the door It is possible to reverse the door on this refrigerator, if required. To do so, follow the steps below: 1. Carefully tilt the appliance to allow access to the base of the appliance. 2. Remove the height adjustable feet. 3. Remove the lower hinge plate. 4. Lift off the door and carefully put it to one side. 5. Remove the top hinge plate. Change the hinge pin on the plate over and then replace the hinge plate on the alternate side of the door frame. 6. Remove the hinge pin receiver and blank at the top of the door and replace on the alternate side. 7. Relocate the door on the top hinge pin. 8. Refit the lower hinge plate. 9. Refit the height adjustable feet. Setting the temperature • The temperature is regulated by the thermostat dial, found inside the fridge compartment on the right hand side. • The thermostat can be adjusted between 1 (least cold) and 5 (coldest). • To switch off the cooling system, turn the thermostat to 0. Use • Never put liquids in the refrigerator uncovered. • Never put hot foods in the refrigerator. Warm food should be allowed to cool to room temperature before being put into the refrigerator. • Nothing should rest against the internal rear wall of the refrigerator, as this will cause frost and possible condensation problems which will be difficult to remove. Using the ice box The ice-box door is fitted with an indicator to show whether the door is fully closed. The door should be kept closed to prevent the contents of the ice-box defrosting, heavy build up of frost in the ice-box and excessive unnecessary use of energy. The indicator is shown in the diagram to the right. • The Door Open indicator shows red when the door is not closed properly. • The Door Open indicator shows white when the door is fully closed. light bulb cover thermostat Setting the temperature • The temperature is regulated by the thermostat dial, found inside the fridge compartment on the right hand side. • The thermostat can be adjusted between 1 (least cold) and 5 (coldest). • To switch off the cooling system, turn the thermostat to 0. Use • Never put liquids in the refrigerator uncovered. • Never put hot foods in the refrigerator. Warm food should be allowed to cool to room temperature before being put into the refrigerator. • Nothing should rest against the internal rear wall of the refrigerator, as this will cause frost and possible condensation problems which will be difficult to remove. Using the ice box The ice-box door is fitted with an indicator to show whether the door is fully closed. The door should be kept closed to prevent the contents of the ice-box defrosting, heavy build up of frost in the ice-box and excessive unnecessary use of energy. The indicator is shown in the diagram to the right. • The Door Open indicator shows red when the door is not closed properly. • The Door Open indicator shows white when the door is fully closed. light bulb cover thermostat Care and cleaning Always disconnect the appliance from the power before any cleaning or maintenance. • The refrigerator section should be cleaned using a solution of bicarbonate of soda and lukewarm water. • Do not use abrasive products or detergents. After washing, rinse and dry thoroughly. • Clean the shelves and balconies separately by hand using soap and water. Do not put them in the dishwasher. • The evaporating tray and water drain hole (at the back of the refrigerator compartment) should be cleaned periodically to prevent the defrosted water from collecting inside the refrigerator compartment. The drain plug can be used to clear the drain hole. • Once cleaning is complete, then reconnect the power. • If the appliance is not used for prolonged periods of time, unplug and clean the appliance. The doors should be left slightly open to prevent the formation of mildew and smell. Defrosting the fridge The fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge. It is important to keep the channel clear at all times. The defrosted water is collected in the evaporating tray at the back of the appliance....


Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría