Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
Take down CAP HOLE TOP at COVER TOP FRONT and install it on the right of COVER TOP FRONT. 2. Take down SCREW A, SCREW E and MID HINGE of the fixing hinge and then freezer door. Take down CAP HINGE HOLE, CAP SCREW CABI and SCREW F at left and install them at right. 3. Gently incline the appliance in less than 45 degree, remove the right FOOT and unfasten SCREW D. Take down right HINGE LOW. Then take down FIX HINGE LOW, and STOPPER HINGE LOW. Reverse STOPPER HINGE LOW and fix it to the left of HINGE LOW with FIXER HINGE LOW and . 4. Take down the left FOOT and unfasten SCREW D. Take down and fix REINF to the right. Then fix FOOT. 5.Take off the SCREW G and STOPPERDOOR in the freezer door and install them at the left of the door. Take off CAP HOLEDOOR, CAP SCREW HANDLE, SCREW C, HANDLE UPP, HANDLE BAR, HANDLE LOW, CAP HANDLE, and CAP SPACER DOOR, and install them at the right of the door. Install CAP HOLEDOOR on the left of the door. 6.Install the freezer's door, and fix MID HINGE with SCREW A and SCREW E. Fix the refrigerator's door with SCREW A and HINGE UP L. 7.Fix the wire inserts properly. Install COVER HINGE UPP L and cover it with COVER DOOR UPP. 8.Install COVER TOP FRONT and finally fasten SCREW B. SHIFT HINGE SHIFT HINGE Changing Safety Precautions the direction of the door opening(RL34EG*) When comparing the appliance with other refrigerators, please refer to the model and number; Before the appliance is connected to the power, verify if voltage rating of the refrigerator is same to the power voltage. The voltage can be variable from 187V to 240V; if the power voltage can not meet the requirements, an automatic transformer with a minimum output of 500W shall be used. If the appliance is disconnected from the power, you should wait for at least five minutes before reconnection; otherwise there may be a hazard to the compressor. Do not store food close to the temperature sensor; otherwise it may display wrong temperatures. Do not open and close the door too frequently or for a long time during hot weather; otherwise it may affect the efficiency of the entire unit and burden the appliance with excessive load. Do not leave the refrigerator upside down or horizontal or keep inclined over 45 degree to the ground if necessary; Do not pull or push the appliance by holding the door handles or exert too much upward/ downward forces on the door handle; If a lot of hot foods are stored at the same time or the door is opened frequently or kept open for a long period of time, the internal temperature will rise and the temperature display may flash. It will be recovered normal after a period of stable operation; The refrigerator must be located with an easy access to the power supply. 1.Remove all the packing materials of the components, and do remove the foam pad under the refrigerator during the operation; 2.Clean the interior and exterior of the refrigerator with wet warm cloth (add little neutral detergent in the warm water). 3.the power plug can be connected around one hour after the refrigerator is positioned stable,please make the approciate operations with careful reference to the page of control panel introduction. Preparing the appliance for use Caution The cooling effects originat...
Otros modelos de este manual:Refrigeradores - RL34ECMB (1.52 mb)
Refrigeradores - RL34ECMS (1.52 mb)
Refrigeradores - RL34ECPS (1.52 mb)
Refrigeradores - RL34EGMS (1.52 mb)