Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
The rinsing water must not run into the light. 5. Wipe the door seal with clear water only and then wipe dry thoroughly. 6. After cleaning reconnect and switch the appliance back on. 7. Put the frozen food back in the freezer compartment. Interior fittings All variable parts of the appliance can be taken out for cleaning. Take out glass shelves Pull the glass shelves forwards and take out. Removing the container Fig. 8 Pull out the container all the way, lift at the front and remove. Light ( LED) Your appliance features a maintenance- free LED light. These lights may be repaired by customer service or authorised technicians only. en Tips for saving energy ¦ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source ( e.g. radiator, cooker) . If required, use an insulating plate. ¦ Allow warm food and drinks to cool down before placing in the appliance! ¦ When thawing frozen products, place them in the refrigerator. Use the coldness of the frozen food to cool food. ¦ Open the appliance as briefly as possible. ¦ Occasionally clean the rear of the appliance to prevent an increased power consumption. ¦ If available: Fit wall spacers to obtain the indicated energy rating of the appliance ( see Installation instructions) . A reduced wall gap will not restrict the function of the appliance. The energy rating may then change slightly. The gap of 75 mm must not be exceeded. Operating noises Quite normal noises Droning Motors are running ( e.g. refrigerating units, fan) . Bubbling, humming or gurgling noises Refrigerant is flowing through the tubing. Clicking Motor, switches or solenoid valves are switching on/off. Cracking Automatic defrosting is running. Preventing noises The appliance is not level Please align the appliance with a spirit level. Use the height- adjustable feet or place packing underneath them. The appliance is not free-standing Please move the appliance away from adjacent units or appliances. Containers or storage areas wobble or stick Please check the removable parts and re- insert them correctly if required. Bottles or receptacles are touching each other Move the bottles or receptacles slightly away from each other. en Eliminating minor faults yourself Before you call customer service: Please check whether you can eliminate the fault yourself based on the following information. Customer service will charge you for advice – even if the appliance is still under guarantee! Fault Possible cause Temperature differs greatly from the set value. The light does not function. The LED lis defectivAppliance too long. Light is safter apprRemedial action In some cases it is adequate to switch off the appliance for 5 minutes. If the temperature is too high wait a few hours and check whether the temperature has approached the set value. If the temperature is too low check the temperature again the next day. ight e. See chapter “Light (LED)” section. was open witched off ox. 10 min. When the appliance is closed and opened, the light is on again. Controls have reduced luminosity. When the not used ftime, the the fascia to energy mode. appliance is or some display on switches saving As soon as the appliance is again used, e.g. the door is opened, the display switches back to normal illumination. The temperature in the refrigerator compartment is too cold. A colder temperature in the freezer compartment can also lower the temperature in the refrigerator compartment. This is quite normal. Set the temperature in the refrigerator compartment slightly warmer. Should this not be enough, e.g. if the room temperature is too low, set the freezer temperature warmer. en Fault Possible cause Remedial action Displays do not illuminate. Power failure; the fuse has been switched off; the mains plug has not been inserted Connect mains plug. Check whether the power is on, check the fuses. properly. The temperature in the freezer compartment is too warm. Appliance opened frequently. The ventilation openings have been covered. Do not open the appliance unnecessarily. Remove obstacles. Large quantities of fresh food are being frozen. Do not exceed max. freezing capacity. Freezer compartment door was open for a long time; temperature is no longer reached. The evaporator (refrigeration generator) in the No Frost system is covered in thick ice and can no longer be defrosted fully automatically. To defrost the evaporator, remove the frozen food with the compartments, insulate well and store in a cool location. Switch off the appliance and move it away from the wall. Leave the appliance door open. After approx. 20 min. the condensation begins to run into the evaporation pan, at the rear of the appliance. Fig. 9 To prevent the evaporation pan from overflowing in this case, mopupthe condensation with a sponge. The evaporator is defrosted when the water stops running into the evaporation pan. Clean the interior. Switch the appliance back on again. en Customer service Yo...
Otros modelos de este manual:Refrigeradores - KG36NAS10J/07 (2 mb)