Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
9/B, with a cotton bud to ensure that the condensation can drain. The water conduction channel, Fig. 9/A, can be taken out for cleaning. en ¦ After cleaning, the stopper must be reinserted into the drainage hole of the refrigerator compartment for functional reasons. Interior fittings All variable parts of the appliance can be taken out for cleaning. Taking out the glass shelf “EasyLift” Fig. 4 Move glass shelf all the way upwards and take out. Taking out the door shelf “EasyLift” Fig. 6 Move door shelf all the way upwards and take out. Taking out the fixed glass shelf Fig. 5 Press buttons on the underside and detach from the fixing. Taking out the frozen food container Fig. * Pull out the frozen food container all the way, lift at the front and remove. Note Before inserting the frozen food container with telescopic rails, remove the latter. Removing the container Fig. , Tilt container forwards and take out. To insert the container, place the front of the container on the telescopic rails and push into the appliance. The container is engaged by pushing it into the appliance. en Taking out the humidity filter Fig. 1/21 The humidity filter over the humidity container can be taken out for cleaning. To do this, first take out the humidity container and pull out the humidity filter. Lift off the filter cover, Fig. +, and take out the filter. Clean in lukewarm water, leave to dry and re-assemble. Remove telescopic rails Fig. . 1. Pull out the telescopic rail. 2. Push lock in the direction of the arrow. 3. Detach telescopic rail from the rear pin. 4. Push telescopic rail together, push backwards above the rear pin and disengage. Installing telescopic rails 1. Place the extended telescopic rail on the front pin. 2. Pull the telescopic rail forwards slightly until it engages. 3. Place telescopic rail on the rear pin. 4. Push lock backwards. Odours If you experience unpleasant odours: 1. Switch off the appliance with the On/ Off button. Fig. 1/9. 2. Take all food out of the appliance. 3. Clean interior (see chapter “Cleaning the appliance”). 4. Clean all packages. 5. Seal strong smelling food in order to avoid odours from forming. 6. Switch the appliance on again. 7. Store food in the appliance. 8. Check whether the formation of odours is still occuring after 24 hours. 9. Change odour filter, Fig. -. The odour filter is situated behind the upper “cool-fresh” container. Replacement filters are available from your customer service. Light (LED) Your appliance features a maintenance- free LED light. These lights may be repaired by customer service or authorised technicians only. en Tips for saving energy ¦ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source (e.g. radiator, cooker). If required, use an insulating plate. ¦ Allow warm food and drinks to cool down before placing in the appliance. ¦ Thaw frozen food in the refrigerator compartment and use the low temperature of the fro...
Otros modelos de este manual:Refrigeradores - KI39FP60/02 (2.47 mb)
Refrigeradores - KI39FP60/03 (2.47 mb)
Refrigeradores - KI39FP60/04 (2.47 mb)
Refrigeradores - KI39FP60/05 (2.47 mb)