Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
4. Wait until the layer of frost has thawed. 5. Clean the appliance with a soft cloth, lukewarm water and a little pH neutral washing- up liquid. The rinsing water must not run into the light or through the drainage hole into the evaporation area. 6. Wipe the door seal with clear water only and then wipe dry thoroughly. 7. After cleaning reconnect and switch the appliance back on. 8. Put the food back into the appliance. en Interior fittings All variable parts of the appliance can be taken out for cleaning. Take out glass shelves Fig. 8 To do this, pull out shelf, lift at the front and take out. Taking out extendable glass shelf Fig. 9 Press levers on the underside on both sides, pull forwards glass shelf, lower and swivel out to the side. Condensation channel Fig. 3 Regularly clean the condensation channel and drainage hole with a cotton bud or similar implement to ensure that the condensation can drain. Take out shelves in the door Fig. Lift shelves upwards and take out. Taking out glass shelf above vegetable container Fig. / The glass shelf can be taken out and disassembled for cleaning. Note Before taking out the glass shelf, pull out vegetable container. Removing the container Fig. . Pull out the container all the way and lift to detach it. To insert the container, place on the telescopic rails and push into the appliance. Attach the container by pressing it down. Odours If you experience unpleasant odours: 1. Switch off the appliance with the On/Off button. Fig. 2/1 2. Take all food out of the appliance. 3. Clean interior ( see chapter “ Cleaning the appliance”) . 4. Clean all packages. 5. Seal strong smelling food in order to avoid odours from forming. 6. Switch the appliance on again. 7. Store food in the appliance. 8. Check whether the formation of odours is still occuring after 24 hours. Light ( LED) Your appliance features a maintenance- free LED light. These lights may be repaired by customer service or authorised technicians only. en Tips for saving energy ¦ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source ( e.g. radiator, cooker) . If required, use an insulating plate. ¦ Select 560 mm cavity depth. A smaller cavity depth will result in a higher energy consumption. ¦ Allow warm food and drinks to cool down before placing in the appliance. ¦ Thaw frozen food in the refrigerator compartment and use the low temperature of the frozen food to cool refrigerated food. ¦ Open the appliance as briefly as possible. ¦ Regularly defrost the freezer compartment to remove the layer of frost! A layer of hoarfrost will impair refrigeration of the frozen food and increase power consumption. ¦ Ensure that the freezer compartment door has been closed properly. ¦ Occasionally clean the rear of the appliance to prevent an increased power consumption. ¦ The arrangement of the fittings does not affect the energy rating of the appliance. Operati...
Otros modelos de este manual:Refrigeradores - KI82LAF30G/01 (1.99 mb)