Votos - 1, Puntuación media: 4
(
)
)
|
Resumen del manual
Use only Blue Rhino Global Sourcing, Inc. factory authorized parts. The use of any part that is not factory authorized can be dangerous. This will also void your warranty. Do not use this appliance without reading “Operating Instructions” in this manual. Do not touch metal parts of grill until it has completely cooled (about 45 min.) to avoid burns, unless you are wearing protective gear (pot holders, gloves, BBQ mittens, etc.). When cooking, fire extinguishing materials shall be readily accessible. In the event of an oil grease fire, do not attempt to extinguish with water. Use type BC dry chemical fire extinguisher or smother with dirt, sand or baking soda. Do not install or use in or on boats or recreational vehicles. Do not use grill in high winds. Never lean over the grill when lighting. Do not leave a lit grill unattended, especially keep children and pets away from grill at all times. Do not attempt to move grill when in use. Allow the grill to cool before moving or storing. Storage of grill indoors is permissible only if the tank is disconnected, removed from the grill and properly stored outdoors. Always open grill lid carefully and slowly as heat and steam trapped within grill can severely burn you. Do not attempt to disconnect the gas regulator from the tank or any gas fitting while the grill is in use. Always place your grill on a hard non-combustible, level surface. An asphalt or blacktop surface may not be acceptable for this purpose. Move gas hoses as far away as possible from hot surfaces and dripping hot grease. Keep all electrical cords away from a hot grill. Do not use grill for indoor cooking or heating. TOXIC fumes can accumulate and cause asphyxiation. After a period of storage and/or nonuse, check for leaks, burner obstructions and inspect for any abrasion, wear, cuts to the hose. Failure to open lid while igniting the grill’s burners, or not waiting 5 minutes to allow the gas to clear if the grill does not light, may result in an explosive flame-up. If grill is not in use, the gas must be turned off at the supply tank. Never operate grill without heat plates installed. Always use a meat thermometer to ensure food is cooked to a safe temperature. Please use protective gloves when assembling this product. Do not force parts together as this can result in personal injury or damage to the product. Never cover entire cooking area with aluminum foil. Deaths, serious injury or damage to property may occur if the above is not followed exactly. page no. Exploded View Parts List 1 Lid Handle 55-07-328 2 Warming Rack 55-07-361 3 Temperature Gauge 55-07-358 4 Lid 55-08-103 5 Cooking Grid 55-07-310 6 Heat Plate 55-07-319 7 Top Hinge (2) 55-07-360 8 Bottom Hinge (2) 55-07-306 9 Left Side Shelf 55-07-325 10 Grill Body Assembly 55-07-317 11 Burner (2) 55-08-101 12 RIght Side Shelf 55-07-496 13 Push Button Ignition 55-07-322 14 Control Knob (2) 55-07-308 15 Left Side Shelf Front Panel 55-07-326 16 QCC Clip 55-13-827 17 Regulator/Hose Assembly 55-07-344 18 Right Side Shelf Front Panel 55-07-346 19 Grease Cup 55-07-315 20 Grease Cup Support 55-07-316 21 Top Frame Brace (2) 55-07-359 22 Back Panel 55-07-302 23 Rear Left Leg 55-07342 24 Rear Right Leg 55-07-343 25 Rear Cart Wire 55-07-341 26 LP Gas Tank Retainer Wire 55-07-333 27 Left Cart Wire 55-07-324 28 Front Left Leg 55-07-312 29 Front Panel 55-07-314 30 Front Right Leg 55-07-313 31 Bottom Left Frame Support 55-07-304 32 Bottom Cart Wire (2) 55-07-303 33 Bottom Right Frame Support 55-07-305 34 Hub Cap (2) 55-07-320 35 Wheel (2) 55-07-363 36 Axle 55-07-301 37 Lighting Rod 55-07-331 38 LP Gas Tank Shield 55-07-334 3 2 1 4 5 6 7 7 8 11 8 9 10 12 16 15 13 17 18 20 19 14 21 21 22 38 23 37 24 27 25 29 26 30 28 32 31 33 34 35 36 35 34 Hardware A Screw M6x16 Zinc Plated Phillips Truss Head 27 pcs B Bolt M6x16 Zinc Plated Phillips Hex Head 20 pcs C Nut M10 Zinc Plated 2 pcs D Wing Nut M6 Zinc Plated 2 pcs E Washer o6.4 Zinc Plated 4 pcs F Lock Washer o6.4 Zinc Plated 4 pcs G Rubber Spacer o10.5 x o17.5 x 6 2 pcs H AA Battery 1 pc Tools Required for Assembly (Included) #2 Phillips Head Screwdriver M6 - M10 Wrench 2 pcs 1 DO NOT RETURN PRODUCT TO STORE. For assistance call 1.800.762.1142 toll free. Please have your owner’s manual and serial number available for reference. Note: The serial number can be found on the back of the cart assembly. For Easiest Assembly: • To avoid losing any small components or hardware, assemble your product on a hard level surface that does not have cracks or openings. • Clear an area large enough to layout all components and hardware. • When applicable, tighten all hardware connections by hand first. Once the step is completed go back and fully tighten all hardware. • Follow all steps in order to properly assemble your product. To complete assembly you will need: • (1) Leak Detection Solution (Instructions on how to make solution are included in the “Operating Instructions” section of this manual) • (1) Precision Filled LP Gas Gri...