Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
A/V Receiver/Amplifier +-+- +-+- Splice 4 Conductor Wire 2 Conductor Wire Figure 3.3 - Wiring: Amplifi er to Speakers-4 Conuctor to 2 Conductor Volume Control • One 4 conductor speaker wire runs from the amplifier to a stereo volume control, then one 2 conductor speaker wire runs to each stereo speaker. +-+- +-+- A/V Receiver/Amplifier 4 Conductor Wire 2 Conductor Wire Figure 3.4 - Wiring: Amplifi er to Speakers w/ Volume Control © 2007 • All rights reserved. 5 Storm Series In-wall Speakers • Five 2 conductor speaker wires run from the A/V Receiver to each surround sound speaker. A/V Receiver/Amplifier Figure 3.5 - Wiring: Amplifi er to Speakers-Home Theater A/V Receiver/Amplifier A82SW XOVER 8080120 120 180180 + - + - L R + - + - • One 4 conductor speaker wire runs from the A/V Receiver to the A82SW Passive Subwoofer then one 2 conductor speaker wire runs to each of two stereo speakers. Figure 3.6 - Wiring: Amplifi er to Speaker-Passive Subwoofer Storm Series In-wall Speakers Amplifier/Receiver LR -+ -+ IN OUT +-+- +-+- A82SW L Speaker R Speaker Figure 3.7 - Wiring: Amplifier to Subwoofer to Speakers-A82SW Note 1: Low voltage wiring must be run in accordance with the National Electrical Code as well as any other applicable provisions of the local building codes in your area. In some cases (such as commercial installations), running the wire in conduit may be required. If you have any questions concerning the wiring of speakers in your home, contact your local building and inspection department. Note 2: It is recommended that you use quality CL-2 or CL-3 rated stranded speaker wire when installing ATON speakers. Solid-core “Romex” type wire is not acceptable! Use at least 16AWG speaker wire for runs up to 100 feet, and at least 14 AWG speaker wire for runs up to 200 feet. If you must cross high-voltage lines, always do so at a 90 degree angle to avoid audible hum through the speakers!. Note 3: When pre-wiring for In-wall speakers, it is essential to make direct wire runs from the head-end to each speaker. Do not run speaker wires in series or parallel, and do not “daisy-chain” speakers to common wiring. ©2007 • All rights reserved. © 2007 • All rights reserved. 7 Storm Series In-wall Speakers Pre-Wiring The audio/speaker cable runs should be routed from the head-end location (where the amplifi er or A/V Receiver is located) to the speaker rough-in brackets (if used). At the speaker locations, securely fasten the speaker wire to the speaker rough-in bracket. If not using speaker rough-in brackets, staple speaker wire runs in a loose zigzag between the studs where the speaker is to be mounted to make it easier to fi nd the cable after the drywall is installed. Zig-zagging the cable also allows fl exibility in the placement of the speaker. Note: Do not run speaker wires closer than 12" from high voltage wires. Speaker Wire Min 12” High Voltage Wiring Figure 3.8 - Pre-Wiring Mounting Two situations that can exist when mounting In-wall speakers: • Pre...
Otros modelos de este manual:Altavoces - Storm Series A61W (1.04 mb)
Altavoces - Storm Series A60W (1.04 mb)
Altavoces - Storm Series A60W (1.04 mb)
Altavoces - Storm Series A82SW (1.04 mb)