Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
4 Press PROG to start programming. •“A B”appears in the display to indicate the direction of the tape. 5 Select the desired track number using numeric buttons. • Repeat step 5 to continue programming tracks. • The remaining time is shown on the display. If the track is longer than the remaining time, “TM Over”appears on the display. 6 Press R.TIME to continue programming tracks on side B. • Repeat step 5. 7 Choose CD = TAPE by pressing DUBBING MODE, and press DUBBING START to start recording. 2 Automatic tape programming 1 Repeat steps 1 to 3 of “Manual tape programming”. 2 Press REP to start programming. • Programming is done in the order on the CD from side A to side B. When complete, the following display appears. (Example) when 11 tracks have been programmed PROG B You can change the program data following the steps described on page 15, “To change program data”. 3 Choose CD = TAPE by pressing DUBBING MODE, and press DUBBING START to start recording. To stop dubbing Press & on KX-E300. To cancel tape programming Press & on CRX-E300 when dubbing is stopped. English ADDITIONAL INFORMATION Troubleshooting If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. When taking the service, the MDX-E300 or KX-E300 may be needed. For details, contact your authorized YAMAHA dealer or service center. SYMPTOM CAUSE REMEDY RECEIVER The unit does not switch ON when the STANDBY/ON switch is pressed. The AC power cord is not connected or not completely connected. Securely connect the power cord. No sound from one speaker. Loose speaker connections. Connect properly. The sound suddenly goes off. The protection circuit has been activated because of a short circuit, etc. Check that the speaker wires are not touching each other and then turn the unit back on. No sound from an external unit connected with this unit or play does not begin. Incorrect cord connections. Connect the cords properly. If the problem persists, the cords may be defective. Input source selection is not proper. Make a proper input source selection. Sound distorted. The component connected to this unit is disconnected from AC outlet. Connect the AC power cord of the component to an AC outlet. Excessive static in FM broadcasts. Interference from starting motor of a nearby car. Position the FM antenna as high and as far away from nearby roads as possible. Connect using a coaxial cable. Interference from the thermostat of a nearby electrical appliance. Noise increases during stereo broadcasts. Antenna input is too weak due to obstructions or excessive distance from the broadcasting station. Check the antenna c...